Power Level Guidelines. Panasonic KYT936SLEPG, KYT935XLEPG


Add to my manuals
80 Pages

advertisement

Power Level Guidelines. Panasonic KYT936SLEPG, KYT935XLEPG | Manualzz

EN-

46

Electrical Work

Electrical Connections

1. Turn off power.

Turn off power at the circuit breaker or remove fuses to the appliance branch circuit.

2. Connect the power cord.

Connect the power cord in accordance with all governing codes and ordinances.

■ Single-phase connection (220-240 V ~ 50 Hz)

Connect the wires in accordance with the instructions given in the following table and diagram:

Electrical cable Wire connection

N

L

:

Yellow / Green

(Connect to the earth terminal)

N:

Black, Cord No. 2 / 4 / 6

L:

Black, Cord No. 1 / 3 / 5

(Connect to the live terminal)

■ Three-phase connection (380-415 V 3N~ 50 Hz)

Separate the L wires and connect them in accordance with the instructions given in the following table and diagram:

Electrical cable Wire connection

N

L1

L2

L3

:

Yellow / Green

(Connect to the earth terminal)

N:

Black, Cord No. 2 / 4 / 6

L1:

Black, Cord No. 1

L2:

Black, Cord No. 3

L3:

Black, Cord No. 5

(Connect to the live terminal)

Installing the Appliance

WARNING

Do not disassemble the top plate. Connected wire may become loose and cause a malfunction.

Upper filler

1. Fasten the clamps to the appliance.

(2 places at rear)

Place the appliance on the packaging upper filler when fitting clamps to prevent damage to the countertop.

Match the clamp grips with the holes on the sides of the appliance, then slide the clamp from the right to the left to fasten them to the appliance.

Correct

2. Embed the appliance in the countertop cutout while keeping it is as level as possible.

Do not drop the appliance on the countertop.

Press down on top of the appliance to make sure that it rests on the countertop.

Make sure that the spaces between the countertop and the under surface of the appliance are even in the front, rear, left and right.

Incorrect

3. Connect the power cord.

See page 46.

CAUTION

If the cabinet does not have an opening in the front, the wiring needs to be connected before the appliance is embedded into the countertop.

EN-

47

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals