8
Design Guide
For Models ZIFS240 and ZIBS240 with Stainless Steel Door Panels and Handles for Flush and Standard Installation
THE INSTALLATION SPACE
For a flush installation
Install a 1/4”-wide filler strip on the hinge side. The filler strip will act as a spacer between the door case and adjacent cabinets and will prevent interference with the cabinet door swing. Recess the filler strip 1-5/8” back from the front face of the refrigerator, or even with the front edge of the product case (behind the gasket). The width of the opening must be 24 7/8" (including the
1 1/8" filler strip).
Flush
Installation
1 1/8"
CABINET
Filler panel or cleat to be set back even with front of case.
Front edge of product case
Front face 110°
CABINET
PRODUCT CLEARANCES
For Models ZIFI240 and ZIBI240 both are set at 110° door swing from factory with no adjustment or 90° stop.
When installed in a corner:
• Allow 14” minimum clearance on the hinge side for a full 110° door swing.
• Allow 4” min. clearance on the hinge side for the 90° door swing and to allow racks to slide out.
14" Minimum to Wall
90 Door
Swing
B
110 Door
Swing
R
F
90
110
4" Minimum to Wall
For a standard installation
The product must be installed so that the product front will project forward of the adjacent cabinets by the dimensions T or U according to the model in the chart.
This position will allow a full door swing and prevent interference with adjacent cabinetry. The opening between cabinets must be a minimum of dimension K.
NOTE: Clearances are based on the recommended
2-1/4” handle standoff depth.
• Test the door swing. Carefully open and close the door. The door should not rub or catch on adjacent cabinetry.
Choose the location:
• These products may be closed in on the top and three sides as long as the front is unobstructed for air circulation and proper access to the door.
• Do not install these products where the temperature will go below 55°F (13°C) or above 100°F (37°C).
• These products are not designed to be stacked one over the other.
Standard
Installation
Important: Model ZIBS240 is not available with a left hand door swing. DOOR HINGE IS NOT REVERSIBLE.
Right hand models illustrated. Allow the same clearances on the opposite side for left hand fresh food Model ZIFS240.
CABINET
Front edge of product case
T,U
Front face
In a standard installation, the product will project forward of adjacent cabinets. See T,U.
120°
110°
CABINET
T ZIFS240
U ZIBS240
1-5/8”
2-5/8”
31-1000642
