Step 3, Install Custom 3/4” Door Panel and Handle. Monogram ZIFS240NSS, ZIFI240HII, Fresh-Food Refrigerator, ZIBS240NSS, ZIBI240HII

Add to My manuals
16 Pages

advertisement

Step 3, Install Custom 3/4” Door Panel and Handle. Monogram ZIFS240NSS, ZIFI240HII, Fresh-Food Refrigerator, ZIBS240NSS, ZIBI240HII | Manualzz

Installation Instructions

STEP 3 INSTALL CUSTOM 3/4”

DOOR PANEL AND

HANDLE

(ZIFI240 and ZIBI240 models only)

3/4” Overlay Panel Dimensions

Model ZIFI240 and ZIBI240 require a field-installed overlay door panel.

Overlay

Panel

• The overlay panel must be secured to a 1/4” thick backer panel that slides into the trim. A

.10” thick spacer panel must be

Door placed between the overlay and backer panel.

• A custom handle of your choice, supplied by your cabinetmaker,

1/4"

Backer

Panel

.10 Inch

Spacer must be installed on this overlay panel. Countersink all screws into the backer panel. Screws cannot protrude from the backer panel.

IMPORTANT NOTE: Maximum total weight for custom door panel is 25 pounds.

B

3/4” Overlay Panel Dimensions (in inches)

A (Width) B (Height)

1/4” Backer 23-3/16” 29-9/16”

0.10” Spacer 22-1/2” 29-1/16”

3/4” Overlay 23-5/8” 30”

A

Assemble overlay panels with glue and screws.

• Center spacer panel on the backer panel, left to right and top to bottom. Secure the panels with glue.

• Center the spacer/backer panel on the overlay panel.

Secure with glue and screws. Countersink all screws into the backer panel.

Overlay Panel

Spacer Panel

STEP 3 INSTALL CUSTOM 3/4”

DOOR PANEL AND

HANDLE

(ZIFI240 and ZIBI240 models only)

Custom Panel Hinge Routing Dimensions

Use a 3/4” router bit to cut a notch into the back side of the assembled panel 3/8” toward the front of the overlay panel, 3/4” deep and 7/8” wide.

3/4”

NOTE: Right-hand models illustrated. Cut notches on the opposite side for left-hand fresh food door swing models

ZIFI240 and ZIFS240.

3/8”

7/8”

3/8”

7/8”

3/4”

Back side of custom panel

Install custom door panel and handle:

• Open door to 90°.

• Remove 5 screws holding trim; lift off trim.

Retain screws.

NOTE: Right-hand models illustrated. Follow the same instructions on the opposite side for left-hand fresh food door swing models ZIFI240 and ZIFS240.

Backer Panel

• A custom handle of your choice, supplied by your cabinetmaker, must be installed onto the overlay panel before the panels are slid into the trim. Countersink all screws into the backer panel. Screws cannot protrude from the backer panel.

Screws Must

Be Countersunk

Into Panel

Handle

Custom

Door Panels

13

31-1000642

advertisement

Related manuals