Change network setting. Schneider Electric SW ABILIT.CBS/SPACELYNK/BMS 32 Pages
Change network setting. Schneider Electric SW ABILIT.CBS/SPACELYNK/BMS
Schneider Electric SW ABILIT.CBS/SPACELYNK/BMS enables system integrators to develop customized applications that can access system data, control devices, and create new visualizations. It provides a secure and reliable way to connect to Schneider Electric devices and systems, and to create custom applications that can be tailored to the specific needs of a building or facility.
Some of the possible use cases for Schneider Electric SW ABILIT.CBS/SPACELYNK/BMS include:
- Monitor and control HVAC systems
- Monitor and control lighting systems
- Monitor and control security systems
- Monitor and control energy consumption
advertisement
4.2
Change network setting
Left click on System
1
Figure 5: spaceLYnk configurator home page
System opens a new page.
On the Network tab, Left click on Interfaces
2
2
Figure 6: System window
System opens the Interfaces setting window
Left click on eth0
3
3
Figure 7: Interfaces setting window
System opens the Interfaces eth0 setting window.
1
AN019_v1-1_EXW-P-C_connected_to SBO_via spaceLYnk
Page 13 / 32
Select “Static IP” in Protocol
4 combobox.
Set the static IP address in IP address
5
.
Set the Network Mask
6
.
Set the Gateway IP
7
.
Set the PDNS server
8
.
Left click on OK
9
4
5
6
7
8
9
Figure 8: Interfaces eth0 setting window
Left click on Apply changes
10 in the upper right of the window. The spaceLYnk will be restarted.
10
Figure 9: Apply changes
Disconnect the Ethernet cable between spaceLYnk and your PC.
Connect spaceLYnk to your network with Ethernet cable.
Access to the spaceLYnk with new address IP to check the network configuration.
The spaceLYnk network is configurated.
AN019_v1-1_EXW-P-C_connected_to SBO_via spaceLYnk
Page 14 / 32
advertisement