EC Declaration of Conformity. DeVilbiss SRI PRO series

SB-2-855-B Page 3

EC Declaration of Conformity

We, Finishing Brands UK Ltd ., Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the manufacturer of the Spray gun model SRi-PRO, declare, under our sole responsibility, that the equipment to which this document relates is in conformity with the following standards or other normative documents:

BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the protection requirements of Council Directive 98/37/EEC relating to Machinery Safety Directive, and;

EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective Systems intended for use in Potentially Explosive Atmospheres protection level II 2 G X . This product also complies with the requirements of the EPA guidelines, PG6/34 .

D . Smith, Vice President

1st May 2012

Finishing Brands UK Ltd . reserve the right to modify equipment specification without prior notice .

Operational Description

This SRi PRO Spray Gun is a professional quality gun designed with both high volume, low pressure (HVLP) technology or Trans-Tech ® technology . HVLP Technology reduces overspray and limits air cap pressure to 0 .7 bar (10 psi) (complies with rules issued by SCAQMD and other air quality authorities) . Trans-Tech technology, when tested under recommended conditions with automotive refinishing materials, has been found to exceed 65% transfer efficiency .

IMPORTANT: These Sprayguns are suitable for use with both waterbased and solvent based coating materials . These guns are not designed for use with highly corrosive and/or abrasive materials and if used with such materials it must be expected that the need for cleaning and/or replacement of parts will be increased . If there is any doubt regarding the suitability of a specific material, contact your DeVilbiss

Distributor or DeVilbiss direct .

NOTE: This gun is not to be used with halogenated hydrocarbon solvents or cleaning agents such as

1,1,1,-Trichloroethane or methylene chloride . These solvents can react with the aluminium components used in this gun and cup . The reaction can become violent and lead to an equipment explosion .