Troubleshooting
November 2022
Configuration and Use Manual
00809-0100-1600
Recommended actions
1. Check your process conditions against the values reported by the device.
2. Verify all of the characterization or calibration parameters. See the sensor tag or the calibration sheet for your meter.
3. Check the wiring between the sensor and the transmitter.
4. Check for tube erosion, especially if the process fluid is abrasive.
5. Perform Smart Meter Verification.
17.8 Discrete Output troubleshooting
17.8.1 No Discrete Output
Cause
• Output not powered
• Wiring problem
• Circuit failure
Recommended actions
1. Check the power supply and power supply wiring.
2. Verify the output wiring.
3. Verify that the channel is wired and configured as a Discrete Output.
4. Contact customer service.
17.8.2 Loop test failed
Cause
• Output not powered
• Power supply problem
• Wiring problem
• Circuit failure
Recommended actions
1. Check the power supply and power supply wiring.
2. Verify the output wiring.
3. Contact customer service.
17.8.3 Discrete Output readings reversed
Cause
• Wiring problem
• Configuration does not match wiring
180 Micro Motion 1600 with Ethernet Transmitters
