Factory Reset. Strymon Flint v2 44 Pages
Strymon Flint v2 packs a '60s spring, '70s plate, and '80s hall reverb, along with three distinct vintage-inspired tremolo effects modeled after units from the '60s and '60s. Tremolo modes include harmonic filtering, bias-modulated tube emulation, and photocell-based "pulsing." Connect an expression pedal or MIDI controller for flexible real-time control over parameters.
advertisement
Flint
- tremolo & reverb
Factory Reset
Performing a Factory Reset restores the pedal to its factory default
Power-up modes and secondary functions, and replaces all stored presets with their factory default settings�
1 Press and hold the REVERB ON footswitch while connecting power to the pedal� Once both LEDs flash, release the footswitch�
2 Sweep the SPEED knob from 0-100% and back two times� Both LEDs will change colors at the extremes of the knob range and blink RED to indicate when the reset is taking place�
• TURN 1: AMBER
• TURN 2: RED
• TURN 3: AMBER
• TURN 4: Both LEDs flash RED , Flint resets and restarts� pg 33
Flint
- tremolo & reverb
Factory Reset (cont.)
FACTORY DEFAULT SETTINGS
EXP/MIDI Jack: Assigned to Expression mode and configured to control the SPEED knob
Input Level: Instrument
Bypass Mode: True Bypass
MIDI Channel: 1
MIDI Output Mode: Off
MIDI Clock Sync: Off
MIDI Expression: On
Live Edit, Secondary
Functions:
TREMOLO BOOST/CUT = 12 o’clock, no Boost/Cut
REVERB BOOST/CUT = 12 o’clock, no Boost/Cut
TAP DIVISION = 100%, 1/4 note
EFFECT ORDER = 0%, Reverb > Tremolo
PRE-DELAY = 0%, minimum PreDelay time
Initial Default Knob & Switch Settings pg 34
advertisement
