Appendix 3: Live Edit Controls Quick Reference. Strymon Flint v2 44 Pages
Strymon Flint v2 packs a '60s spring, '70s plate, and '80s hall reverb, along with three distinct vintage-inspired tremolo effects modeled after units from the '60s and '60s. Tremolo modes include harmonic filtering, bias-modulated tube emulation, and photocell-based "pulsing." Connect an expression pedal or MIDI controller for flexible real-time control over parameters.
advertisement
Flint
- tremolo & reverb
Appendix 3: Live Edit Controls
Quick Reference
pg 42
Flint
- tremolo & reverb
Live Edit Controls Quick Reference
Flint provides a way to adjust several secondary functions that are avail-
able on several knobs� (Also, see “Live Edit Functions” on page 7
�)
Live Edit Functions are saved per preset�
1 Press and hold the REVERB ON footswitch until both LEDS blink to enter Live Edit mode�
2 Release the footswitch and use the knobs as described below�
3 Press REVERB ON footswitch to store setting and exit Live Edit mode�
TREMOLO BOOST/CUT
for an illustrated description�
REVERB BOOST/CUT
illustrated description�
TAP DIVISION
illustrated description�
EFFECT ORDER
illustrated description�
PRE-DELAY
illustrated description�
MIDI CLOCK SYNC
illustrated description�
MIDI EXPRESSION
for an illustrated description�
Turn the INTENSITY knob—both LEDs change color from GREEN (-3dB cut) to AMBER (+3dB boost) as the control is adjusted� As the default, no
Boost/Cut is applied
Turn the MIX knob—both LEDs change color from
GREEN (-3dB cut) to AMBER (+3dB boost) as the control is adjusted� As the default, no Boost/Cut is applied
Turn the SPEED knob—both LEDs change color as the control is adjusted
• 1/16 = RED
• Triplet = AMBER
• 1/8 = GREEN
• 1/4 = BLUE (default)
Turn the DECAY knob—the TREMOLO ON LED changes color from
• Reverb > Tremolo = GREEN (default)
• Tremolo > Reverb = RED
Turn the COLOR knob—the REVERB ON LED changes color from GREEN (minimum, default) to
AMBER (maximum) as the control is adjusted
Set the REVERB type switch to the ‘80s (down) or
‘60s (up) position—status is momentarily shown on both LEDs
• ‘80s position: OFF , RED (default)
• ‘60s position: ON , BLUE
Set the TREMOLO type switch to the ‘65 photo
(down) or ‘61 harm (up) position—status is momentarily shown on both LEDs
• ‘65 photo position: OFF , RED
• ‘61 harm position: ON , BLUE (default) pg 43
advertisement
