Specifications. Panasonic PT-LW376

Add to my manuals
146 Pages

advertisement

Specifications. Panasonic PT-LW376 | Manualzz

Chapter 7 Appendix - Specifications

Specifications

The specifications of the projector are as follows.

Power supply

Power consumption

Power consumption

(during standby)

LCD panel

Display method

Drive method

Lens

Color system

Projection size

Cabinet

Outer color

Panel size

Pixels

Manual zoom

Manual focus

Luminous lamp

Light output * 1

Center to corner zone ratio *1

Contrast ratio * 1

Screen aspect ratio

Projection method

Built-in speaker

Power cable length

110 V (110 V alternating current), 60 Hz (for Taiwan)

100 V - 240 V (100 V - 240 V alternating current), 50 Hz/60 Hz (for other countries or regions)

3.5 A - 1.5 A, 300 W

3.1 A, 300 W (for Taiwan)

When [STANDBY MODE] is set to [ECO]: 0.5 W

When [STANDBY MODE] is set to [NETWORK]: 1 W

PT-LW376, PT-LW336, PT-LB426,

PT-LB386, PT-LB356

PT-LB306

When [STANDBY MODE] is set to [NORMAL], [IN STANDBY

MODE] of [AUDIO SETTING] is set to [OFF], <USB A (VIEWER/

WIRELESS/DC OUT)> terminal is not in use: 6 W

When [STANDBY MODE] is set to [NORMAL], [IN STANDBY

MODE] of [AUDIO SETTING] is set to [ON], <USB A (VIEWER/

WIRELESS/DC OUT)> terminal supplies power (2 A): 35 W

When [STANDBY MODE] is set to [NORMAL], [IN STANDBY

MODE] of [AUDIO SETTING] is set to [OFF]: 6 W

When [STANDBY MODE] is set to [NORMAL], [IN STANDBY

MODE] of [AUDIO SETTING] is set to [ON]: 10 W

PT-LW376, PT-LW336

PT-LB426, PT-LB386, PT-LB356,

PT-LB306

1.5 cm (0.59") (aspect ratio 16 : 10)

1.6 cm (0.63") (aspect ratio 4 : 3)

Translucent screen LCD panel 3 panels, 3 primary color system

Active matrix method

PT-LW376, PT-LW336

PT-LB426, PT-LB386, PT-LB356,

PT-LB306

1.2 x

PT-LW376, PT-LB426, PT-LB386,

PT-LB356

PT-LW336, PT-LB306

230 W UHM lamp

1 024 000 pixels (1 280 x 800 dots) x 3 panels

786 432 pixels (1 024 x 768 dots) x 3 panels

F = 1.6 ~ 1.76, f = 19.16 mm ~ 23.02 mm

F = 2.1 ~ 2.24, f = 19.11 mm ~ 22.94 mm

PT-LW376

PT-LW336, PT-LB306

PT-LB426

PT-LB386

3 600 lm

3 100 lm

4 100 lm

3 800 lm

PT-LB356 3 300 lm

When [PICTURE MODE] is set to [DYNAMIC], [LAMP POWER] is set to [NORMAL], [AUTO POWER

SAVE] is set to [OFF], and [DAYLIGHT VIEW] is set to [OFF]

85%

20 000 : 1 (When [PICTURE MODE] is set to [DYNAMIC], [LAMP POWER] is set to [NORMAL], [IRIS] is set to [ON], [AUTO POWER SAVE] is set to [OFF], and [DAYLIGHT VIEW] is set to [OFF])

7 (NTSC, NTSC4.43, PAL, PAL-N, PAL-M, SECAM, PAL60)

0.76 m - 7.62 m (30" - 300")

PT-LW376, PT-LW336 16 : 10

PT-LB426, PT-LB386, PT-LB356,

PT-LB306

4 : 3

[FRONT/DESK], [FRONT/CEILING], [REAR/DESK], [REAR/CEILING]

PT-LW376, PT-LW336, PT-LB426,

PT-LB386, PT-LB356

PT-LB306

2.0 m (78-3/4") (for Taiwan)

10 W (monaural) x 1

2 W (monaural) x 1

1.8 m (70-7/8") (for other countries or regions)

Molded plastic

White

140 - ENGLISH

Chapter 7 Appendix - Specifications

Dimensions

Weight

Noise level * 1

Width: 335 mm (13-3/16")

Height: 96 mm (3-25/32") (when adjustable foot shortened)

Depth: 252 mm (9-29/32")

PT-LW376, PT-LW336, PT-LB426,

PT-LB386, PT-LB356

PT-LB306

When set to [NORMAL] in [LAMP POWER] : 38 dB

When set to [ECO] in [LAMP POWER] : 35 dB

When set to [QUIET] in [LAMP POWER] : 30 dB

Approx. 2.9 k

Approx. 2.8 k g g

(6.39 lbs.) *

(6.17 lbs.) *

2

2

5 °C (41 °F) to 40 °C (104 °F) (Elevation: below 1 400 m (4 593'))

5 °C (41 °F) to 35 °C (95 °F) (Elevation: 1 400 m (4 593') ~ 2 700 m (8 858')) Operating environment

Remote control

Operating environment temperature * 3

Operating environment humidity

Power supply

Operating range

Weight

Dimensions

20 % to 80 % (no condensation)

DC 3 V (AAA/R03/LR03 battery x 2)

Approx. 7 m (22'11-5/8") (when operated directly in front of receptor)

63 g (2.22 ozs.) (including batteries)

Width : 44 mm (1-23/32"), Length : 105 mm (4-1/8"), Height : 20.5 mm (13/16")

*1 Measurement, measuring conditions and method of notation all comply with ISO/IEC 21118:2020 international standards.

*2 This is an average value. It may differ depending on individual product.

*3 When [LAMP POWER] is set to [NORMAL] and the projector is operated at an elevation of 1 400 m (4 593') or less, if the ambient temperature exceeds 35 °C (95 °F), [LAMP POWER] will be switched to [ECO] automatically to protect the projector; When [LAMP

POWER] is set to [NORMAL] and the projector is operated at an elevation between 1 400 m (4 593') and 2 700 m (8 858'), if the ambient temperature exceeds 30 °C (86 °F), [LAMP POWER] will be switched to [ECO] automatically to protect the projector.

Note f The part numbers of accessories and separately sold components are subject to change without notice.

r

Connecting terminal

<COMPUTER 1 IN> terminal

<COMPUTER 2 IN/1 OUT> terminal *1

<MONITOR OUT> terminal *2

<VIDEO IN> terminal

<HDMI IN> terminal *2

<HDMI 1 IN>/<HDMI 2 IN> terminal *1

<AUDIO IN 1> terminal

<AUDIO IN 2> terminal

<VARIABLE AUDIO OUT> terminal

<USB A (VIEWER/WIRELESS/

DC OUT)> terminal *1

<USB B > terminal *2

<SERIAL IN> terminal

<LAN> terminal *1

1 (High-density D-sub 15 pin female)

RGB signal

YP

B

P

R

signal

Y/C signal

0.7 V [p-p] 75 Ω

HD/SYNC TTL high impedance, automatic positive/negative polarity compatible

VD TTL high impedance, automatic positive/negative polarity compatible

(HD/SYNC and VD do not support 3 value SYNC.)

Y: 1.0 V [p-p] including synchronization signal, P

B

P

R

: 0.7 V [p-p] 75 Ω

Y: 1.0 V [p-p] C: 0.286 V [p-p] 75 Ω S1 signal compatible

1 (High-density D-sub 15 pin female)

RGB signal

YP

B

P

R

signal

0.7 V [p-p] 75 Ω

HD/SYNC TTL high impedance, automatic positive/negative polarity compatible

VD TTL high impedance, automatic positive/negative polarity compatible

(HD/SYNC and VD do not support 3 value SYNC.)

Y: 1.0 V [p-p] including synchronization signal, P

B

P

R

: 0.7 V [p-p] 75 Ω

1 (High-density D-sub 15 pin female)

RGB signal

YP

B

P

R

signal

0.7 V [p-p] 75 Ω

HD/SYNC TTL high impedance, positive/negative polarity compatible

VD TTL high impedance, positive/negative polarity compatible

Y: 1.0 V [p-p] including synchronization signal, P

B

P

R

: 0.7 V [p-p] 75 Ω

1 (Pin jack 1.0 V [p-p] 75 Ω)

1 (HDMI 19 pin, HDCP and Deep color compatible)

Audio signal Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)

2 (HDMI 19 pin, HDCP and Deep color compatible)

Audio signal Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)

1 (M3 stereo mini jack, 0.5 V [rms], input impedance 22 kΩ and more)

1 (Pin jack x 2 (L-R), 0.5 V [rms], input impedance 22 kΩ and more)

1 (M3 stereo mini jack, stereo monitor output compatible,

0 V [rms] to 2.0 V [rms] variable, output impedance 2.2 kΩ and less)

USB connector (type A x 1)

Memory Viewer / Wireless module (Model No.: AJ-WM50 / ET-WML100) compatible / power supply (DC

5 V, maximum 2 A)

USB connector (type B x 1), for service use

1 (D-sub 9 pin, RS-232C compliant, for computer control use)

1 (for RJ-45 network connection, PJLink (Class 2) compatible, 10Base-T/100Base-TX)

*1 Only for PT-LW376, PT-LW336, PT-LB426, PT-LB386 and PT-LB356

*2 Only for PT-LB306

ENGLISH - 141

Chapter 7 Appendix - Specifications r

Wireless LAN

(Only for PT-LW376, PT-LW336, PT-LB426, PT-LB386 and PT-LB356)

To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module (Model

No.: AJ-WM50 / ET-WML100).

Compliance standards

Transmission method

Frequency range

(Channel)

Transmission speed

(Standard value)

Encryption method

IEEE802.11b/g/n

DSSS, OFDM

2 412 MHz to 2 462 MHz (1 to 11 ch)

IEEE802.11n

IEEE802.11g

IEEE802.11b

WPA2-PSK(AES)

Maximum 144 Mbps (for AJ-WM50)

Maximum 150 Mbps (for ET-WML100)

Maximum 54 Mbps

Maximum 11 Mbps r

Compatible signals

Refer to “List of compatible signals” ( x page 138) for the types of video signals that can be used with the projector.

For Video signal

For Y/C signal

For RGB signal

For YC

B

C

R

/YP

B

P

R

signal

For HDMI signal

Horizontal : 15.73 kHz, Vertical : 59.94 Hz

Horizontal : 15.63 kHz, Vertical : 50.00 Hz

Horizontal : 15.73 kHz, Vertical : 59.94 Hz

Horizontal : 15.63 kHz, Vertical : 50.00 Hz

Displayable resolution: 640 x 400 to 1 920 x 1 200

Dot clock frequency: 162 MHz or less

Displayable resolution: 480i/576i to 1 920 x 1 080

Dot clock frequency: 148.5 MHz or less

Displayable resolution for movie-based signals: 480i/576i *1 to 1 920 x 1 080

Displayable resolution for still image signals: 640 x 400 to 1 920 x 1 200 (non-interlaced)

Dot clock frequency: 25 MHz to 162 MHz

*1 Pixel-Repetition signal (dot clock frequency 27.0 MHz) only

142 - ENGLISH

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents