Preparing the remote control. Panasonic PT-MZ680

Add to my manuals
210 Pages

advertisement

Preparing the remote control. Panasonic PT-MZ680 | Manualzz

Chapter 1   Preparation — Preparing the remote control

Preparing the remote control

Inserting and removing the batteries

(ii)

(i)

Fig. 1 Fig. 2

1) Open the cover. (Fig. 1)

2) Insert the batteries and close the cover (insert the m side first). (Fig. 2) f

When removing the batteries, perform the steps in reverse order.

When using the multiple projectors

When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector individually using single remote control, if a unique ID number is assigned to each projector.

When using the projectors by setting the ID numbers, set the ID number of the projector body after initial settings have been completed. Then, set the ID number of the remote control. For initial settings, refer to “When the initial setting screen is displayed” ( x page 55).

The factory default ID number of the projector (projector body and remote control) is set to [ALL], so you can use it as it is. Set the ID numbers of the projector body and remote control as necessary.

For details on setting the ID number of the remote control, refer to “Setting ID number of the remote control”

( x page 72).

Note f

Set the ID number of the projector body from the [PROJECTOR SETUP] menu → [PROJECTOR ID].

Connecting the remote control to the projector with a cable

To control the projector with a wired remote control, connect the remote control wired terminal of the remote control with the <REMOTE 1 IN> terminal of the projector with commercially available M3 stereo mini jack cable.

This is effective when using the projector in location where there is an obstacle between the projector and the remote control or location that is affected by the outside light.

f The wireless remote control cannot be used when a cable is connected to the <REMOTE 1 IN> terminal of the projector.

Remote control

M3 stereo mini jack cable

(commercially available)

Connecting to the remote control wired terminal

Connecting terminals

Attention f

Use a cable that is 15 m (49'3") or shorter, with 2 core shielded. The remote control may not operate when the length of the cable exceeds

15 m (49'3") or when the shielding of the cable is inadequate.

34 - ENGLISH

Chapter 2

Getting Started

This chapter describes things you need to do before using the projector such as the setup and connections.

ENGLISH - 35

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents