Inspection and Testing. Jacuzzi SOAKER BATH SERIES

Soaker™ Bath Series

Inspection and Testing

Visual Inspection

1 Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only.

2 Inspect the shell and bathtub components. Should inspection reveal any damage or defect in the finish or visible damage to any components, do not install the bathtub. Damage or defect to the finish claimed after the bathtub is installed is excluded from the warranty. Jacuzzi Luxury Bath’s responsibility for shipping damage ceases upon delivery of the products in good order to the carrier.

3 Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty information packed with the product or in the back of this manual.

Installation

A technical specifications manual has been included with your bathtub. The Technical Specifications Manual will contain pertinent information regarding your Jacuzzi Luxury Bath product. Locate the Technical Specifications Manual at this time.

Framing

Frame out the space where the bathtub is to be located. The following should be taken into consideration when preparing the area:

•

Dimensions provided on rough-in diagrams are nominal.

Measure your actual unit upon receipt and build

according to the actual dimensions.

•

The floor structure beneath the bathtub must be able to

support the total weight of the bathtub, water and bather.

Please refer to the Technical Specifications Manual

(column marked ‘Total Weight/ Floor Loading’).

•

The unit must be supported from the bottom of the

installations, take into account the thickness of the

surround material and finishing material (marble, tile,

etc.).

•

Ensure the rim will rest on a level surface.

•

Per code, access must be provided to the chromatherapy

control panel box (if equipped). Service access

locations are shown in the rough-in diagrams contained

in the Technical Specifications Manual (Figure 1).

It is the responsibility of the installer, building contractor, or owner to provide access for service.

Jacuzzi is not responsible for any costs relating to obtaining access for repair. The owner shall bear such costs and, if appropriate, must seek recovery from the installer.

CHROMATHERAPY

LIGHT LOCATIONS

F

OVERFLOW

Figure 1 - Common Access Location

Page 6 www.jacuzzi.com

Installation and Operation