advertisement
NEVER LEA VE THE HEA TER UNA TTENDED WHILE BURNING!
ATTENTION - CRITICAL POINTS TO
REMEMBER!
• Propane (LP) gas has a distinctive odor. Learn to
LOCATION
B. Each heater is equipped with a 100% safety shutoff, push
• Even If you are not property trained in the service and shuts off the burner in the event of tipping. Ensure that this switch is in the vertical position and is secured with the screws provided
(see Fig. 2). DO NOT operate this heater with the LP-gas
C. Before proceeding with this installation, be sure to inspect light heater, perform service or repairs, or make any potential for physical damage to the appliance (i.e., due to physical contact) is reduced to a minimum.
LOCATION
Although this heater incorporates a “tip over” switch, the heater and LP-Gas supply cylinder must be located on a hard, flat, practice under any conditions. If you smell even a small amount of gas, CONTACT YOUR FUEL GAS SUPPLIER
FOR SAFE OPERATION
A. READ THESE INSTRUCTIONS CAREFULLY. Read and who has not read these instructions to assemble, light,
B. LP-Gas IS HIGHLY FLAMMABLE.
In the event of a leak,
•
Never strike a match, bring any flame or create an electric spark in an enclosure when you smell LP-Gas. Ventilate the area thoroughly, move the heater outside, and correct the source of the leak before attempting to light any appliance.
C. Always operate the heater with the LP-Gas cylinder in an upright position on a level non-combustible surface. NEVER accidental tipping. DO NOT OPERATE this heater with the supply cylinder in any other than the upright position.
The heater must be installed in a location such that it will not be
This appliance must be installed only in locations where the potential for physical damage to the appliance (i.e., due to physical contact) is reduced to a minimum.
efficiency. If possible, operate the unit in a draft free area or turn
The installer must inform the owner/operator of this appliance that precautions must be taken to protect the appliance from physical damage.
at least six feet away from any LP-Gas container and must not be
For Model HS35LP
D. DO NOT attempt to operate the heater with any gas other than that indicated on the heater nameplate.
be replaced prior to the heater being put into operation. The replacement hose assembly shall be that specified by the manufacturer. See the parts list.
INSTALLATION INSTRUCTIONS
these codes,
DO NOT operate this heater with the LP-gas
• With the (U.S.) National Fuel Gas Code, ANSI Z223.1 – Latest
Edition, AND with the (U.S.) Standard for the Storage and
Handling of Liquified Petroleum Gases, ANSI/NFPA 58, OR
• With the current (Canadian) CAN/CGA B149.1 AND B149.2
INSTALLATION CODES.
This heater (including hose and regulator assembly) must be inspected before each use and at least annually by a qualified service person. If the hose for Model HS35LP shows evidence of excessive abrasion or wear, or if the hose is cut, it must be replaced prior to the heater being put into operation. The replacement hose assembly shall be that specified by the manufacturer. See the parts list.
Use of this heater in a draft/windy area may decrease its efficiency. If possible, operate the unit in a draft free area or turn
If connected to a self-contained LP-Gas supply system, the hose assembly must be inspected prior to each use of the heater. If it is
PIPING:
it must be replaced prior to the heater being put into operation.
For Model HS35LP
This model may be connected to a self-contained LP-Gas supply system using the hose and regulator assembly supplied with the appliance, OR, it may be connected to a permanently installed
LP-Gas supply system.
If connected to a self-contained LP-Gas supply system, the hose assembly must be inspected prior to each use of the heater. If it is it must be replaced prior to the heater being put into operation.
NEVER USE A FORK LIFT TRUCK TYPE
more than a maximum capacity of 100 pounds of LP-Gas. DO NOT connect this appliance to a cylinder having less than a nominal
20 pound c
NEVER USE A FORK LIFT TRUCK TYPE
CYLINDER.
Gas-Fired Infra-Red Portable Construction Heater
4
Operating Instructions and Owner’s Manual
advertisement
Related manuals
advertisement
Table of contents
- 3 Installation Instructions
- 3 Location
- 3 Piping
- 4 Operating Instructions
- 4 Lighting and Shut Down
- 5 Maintenance Instructions
- 6 Replacement Parts List
- 8 Service and Parts Ordering Information
- 14 Emplacement
- 14 Tuyauterie
- 15 Allumage et arrêt
- 16 Entretien
- 17 Liste des pièces de remplacement
- 19 Service à la clientèle et commande de pièces
- 23 Instrucciones de instalación
- 23 Ubicación
- 23 Tuberías
- 24 Instrucciones de operación
- 24 Encendido y apagado
- 25 Instrucciones de mantenimiento
- 26 Lista de repuestos