advertisement
Operation
10
Pails
Solvent and oil/based fluids: follow local code. Use only conductive metal pails, placed on a grounded surface such as concrete.
Do not place pail on a nonconductive surface such as paper or cardboard which interrupts grounding continuity.
Grounding a metal pail: connect a ground wire to the pail by clamping one end to pail and other end to a true earth ground such as a water pipe.
Pressure Relief Procedure
Follow the Pressure Relief Procedure whenever you see this symbol.
This equipment stays pressurized until pressure is manually relieved. To help prevent serious injury from pressurized fluid, such as skin injection, splashing fluid and moving parts, follow the Pressure
Relief Procedure when you stop spraying and before cleaning, checking, or servicing the equipment.
1. Engage the gun trigger lock. Refer to the separate instruction manual provided with gun for safety features and how to engage the trigger lock.
2. Turn the unit off.
3. Disengage the gun trigger lock and trigger the gun to relieve residual fluid pressure.
Hold metal part of the gun in contact with grounded metal pail. Use minimum pressure.
ti5851a
To maintain grounding continuity when flushing or relieving pressure: hold metal part of spray gun firmly to side of a grounded metal pail. Then trigger gun.
ti15989a
4. Re-engage gun trigger lock and turn Prime Valve to the open (priming) position.
Closed
(Pressure)
Open
(Priming) ti5310b ti17403a
NOTE: The valve handle can move both clockwise and counter clockwise and can face different directions.
NOTE: If you suspect the spray tip or hose is clogged or that pressure has not been fully relieved after following the steps above, VERY SLOWLY loosen tip guard retaining nut or hose end coupling to relieve pressure gradually, then loosen completely. Clear hose or tip obstruction.
332882A
advertisement