Panel Identifier. PARADOX Esprit 748 express +

Panel Settings for Espload the fifth ring. If you call back after 64 seconds the "ring" counter will have been reset and the control panel will answer the call on the eighth ring.

If you program four or less rings, the control panel will always reset the counter!

5.2

Panel Identifier

Streamline - Section 01

? ?

Hexa Programming - Addresses 004-005

This four-digit code identifies the control panel to the Espload software before initiating upload.

Program the same 4-digit code into the control panel and the Espload software before attempting to establish communication. If the codes do not match, the control panel will not establish communication. Enter any hexa digits from 0 to F.

[ ENTER ] + Installer Code + [10] [10] [4] + First 2 digits + [10] [10] [5] + Final 2 digits + [ ENTER ]

5.3

PC Password

Streamline - Section 01

?

Hexa Programming - Addresses 006-007

This four-digit download password identifies the PC to the panel, before beginning the download process. Enter the same password into the Espload software and the control panel. If the passwords are not the same, Espload will not establish communication. Enter any hexa digits from 0 to F.

[

ENTER

] + Installer Code + [10] [10] [6] + First 2 digits + [10] [10] [7] + Final 2 digits + [

ENTER

]

5.4

Computer Telephone Number

Streamline Section 02 & 03

?

Hexa Programming - Address 008-015

The control panel will dial this telephone number when trying to initiate communication with the PC

(see section 5.5 Call Espload ). There is no default telephone number and you can enter any number from 0-9 up to a maximum of 16 digits. If you would like to enter any special keys or functions refer to table 3 in section 6.3. If the telephone number contains less than 16 digits, press the [ TRBL ] key to indicate the end of the telephone number.

[ ENTER ] + Installer Code + [7] + [10] [2] + Telephone Number (if <16 digits press [ TRBL ] ) + [ ENTER ]

5.5

Call Espload

Key Access Programming

?

key [

TRBL

]

The control panel will dial the telephone number entered at addresses 008-015 (see section 5.4) in order to communicate with the Espload software. The control panel and the computer will verify that the Panel Identifier and the PC Password match before establishing communication (see sections

5.2 and 5.3).

Press [

ENTER

] + (Installer, Master, or User 1 Code) + [

TRBL

]

5.6

Answer Espload

Key Access Programming

?

Key [

AWAY

]

By entering the code sequence listed below, you can manually force the control panel to answer any incoming calls from the Espload software. This option can also be used to perform an on-site upload/download by connecting your computer directly to the control panel using an ADP-1 line adapter and manually answering Espload from the control panel. In Espload go to:

17