Location. Miele KWT 2671 ViS

Add to my manuals
100 Pages


Location. Miele KWT 2671 ViS | Manualzz













This appliance should be installed in a dry, well-ventilated room.

When deciding where to install your wine conditioning unit, please bear in mind that it will use more energy if installed near to a heater, a cooker or another appliance that gives off heat. Direct sunlight should also be avoided.

The higher the room temperature, the longer the compressor runs and the higher the energy consumption of the wine conditioning unit is.

When installing the wine conditioning unit, please note the following:

– The socket must be easily accessible in an emergency, not concealed behind the appliance.

– The plug and power cable must not touch the rear of the wine conditioning unit as they could be damaged by vibrations from the appliance.

– Do not plug in other appliances behind this wine conditioning unit.

If installation near a heat source is unavoidable, observe the following minimum distances between the appliance and the heat source:

– At least 3 cm to electric or gas stoves

– At least 30 cm to oil or coal-based stoves

If it is not possible to observe these minimum distances, an isolation plate must be installed between the wine conditioning unit and the heat source.



Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Key Features

  • Built-in 91 bottle(s) Number of temperature zones: 3 Black
  • Number of shelves: 10 Number of doors: 1
  • Wine cooler net capacity: 361 L
  • 42 dB
  • 171 kWh
  • Built-in display Interior light Temperature alarm

Related manuals

Download PDF


Table of contents