Preparation before Operation. Daikin FTXS60BVMA

Preparation before Operation

1

Screws

2

3

Position and

–

Remote controller

„

To set the batteries

1.

Slide the front cover to take it off.

2.

Set 2 dry batteries AAA.LR03 (alkaline).

3.

Set the front cover as before.

„

To fi x the remote controller holder on the wall

1.

Choose a place from where the signals reach the unit.

2.

Fix the holder to a wall, a pillar, etc. with the screws supplied with the holder.

3.

Place the remote controller in the remote controller holder.

Remote controller holder

9

NOTE

„

Notes on batteries

• When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.

• When the system is not used for a long time, take the batteries out.

• The batteries will last for approx. 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs within a year, however, replace both 2 batteries with new, size AAA.LR03 (alkaline).

• The attached batteries are provided for the initial use of the system.

The usable period of the batteries may be short depending on the manufactured date of the air conditioner.

„

Notes on remote controller

• Never expose the remote controller to direct sunlight.

• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.

• Signal communication may be disabled if an electronic-starter-type fl uorescent lamp (such as inverter-type lamps) is in the room. Consult the shop if that is the case.

• If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.

„

Turn the breaker on

• After the power is turned on, the fl aps of the indoor unit opens and closes once to set the reference position.

„

To set the clock

1.

Press .

“

“

” is displayed.

” and “ ” blink.

2.

Press to set the current day of the week.

3.

Press .

“ ” blinks.

4.

Press to set the clock to the present time.

• Holding down or button rapidly increases or decreases the time display.

5.

Press .

• Point the remote controller at the indoor unit when pressing the buttons.

“ ” blinks.

NOTE

„

Note on setting the clock

• If the indoor unit’s internal clock is not set to the correct time, ON/OFF TIMER and WEEKLY TIMER will not operate punctually.

10