Install the 2Wire Gateway USB driver. 2Wire HomePortal 100SW, HOME PORTAL 100SW, 100S, 100SW, HomePortal 100, HomePortal 100W, HomePortal, HomePortal 100S

Add to my manuals
55 Pages

advertisement

Install the 2Wire Gateway USB driver. 2Wire HomePortal 100SW, HOME PORTAL 100SW, 100S, 100SW, HomePortal 100, HomePortal 100W, HomePortal, HomePortal 100S | Manualzz

Install the 2Wire Gateway USB driver

Before installing your HomePortal software, you must install the 2Wire Gateway USB driver on your computer. The following screens show the installation under Windows 98SE and may vary somewhat on

Windows ME, Windows 2000, and Windows XP.

1.

Power on your computer. The Add New

Hardware Wizard opens. Click

Next

to continue.

2.

Select

Search for best driver for your device

and click

Next

to continue.

3.

Place the HomePortal Setup Wizard CD in the

CD-ROM tray and select

CD-ROM drive

. Click

Next

to continue.

Note:

Make sure only the CD-ROM drive is selected. Otherwise, Windows may load the wrong file.

8

4.

Select

The updated driver

and click

Next

.

5.

Click

Next

.

Note:

If asked to insert your Windows CD, please do so and follow the onscreen instructions. If you don’t have your Windows

CD handy, look for the Windows.cab files in the locations listed below:

C:\WINDOWS\options\cab

C:\WINDOWS

C:\WINDOWS\system

C:\Win98

6.

7.

Click

Finish

.

Remove the CD from the CD-ROM tray, then click

Yes

to restart your computer.

IMPORTANT: Don’t forget to reboot your cable or DSL modem after new connections are made and make

sure that your modem is powered on before proceeding.

9

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents