advertisement
10
Operating Instructions
Adjust the Water Softener
To avoid the scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content, water. The dishwasher therefore has a built-in water softener, in which tap water from a hardness of 4 °d (German degree) is softened with the aid of special salt.
3
You water supplier will be able to inform you on the hardness and hardness range of the water in your area.
0 Adjust the water softener to the setting given in the table that corresponds to the hardness of the water in your area. The water softener can be adjusted in 10 steps.
Water Hardness
in °d
1
) in ppm
2
) Range
Adjust to Hardness Setting
Indication on the
Multi-Display
41-50
35-40
31-34
27-30
23-26
19-22
15-18
11-14
730-900
630-720
550-620
480-540
410-470
330-400
260-320
190-250
IV
III
4
3*
2
9
8
7
6
5
H 9
H 8
H 7
H 6
H 5
H 4
H 3
H 2 II
4-10 70-180 under 4 under 70
I/II
I
1
0 no salt necessary
H 1
H 0
1)(°d) German degree, measure of the hardness of water
2)(ppm) Parts Per Million
*factory setting
0 1. The dishwasher must be switched off.
2. Press the function and water softener buttons simultaneously and keep them pressed
3. In addition press the ON/OFF switch.
The LED indicators for the function and water softener buttons flash.
4. Press the softener button again.
The multi-display indicates the hardness setting.
5. Pressing the water softener button increases the hardness setting by 1.
(Exception: hardness setting 0 follows hardness setting 9).
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
advertisement
Table of contents
- 10 Adjust the Water Softener
- 11 Filling with Salt for the Water Softener
- 12 Filling with Rinse Aid
- 13 Adjusting Rinse Aid Dosing
- 13 In Daily Use
- 14 Loading Cutlery and Dishes
- 15 Loading Cutlery
- 16 Loading Pans, Frying Pans and Large Plates
- 17 Loading Cups, Glasses and Coffee Services
- 18 Adjusting the Height of the Upper Basket
- 19 Filling with Detergent
- 20 Bio Wash Programmes and Concentrated Detergents
- 21 Selecting the Wash Programme (Programme Table)
- 22 Start the Wash Programme
- 22 Changing/Interrupting/Cancelling the Wash Programme
- 23 Setting or Changing the Delay Start Timer
- 24 Load Sensing – Sensor Logic
- 24 Switching Off the Dishwasher
- 24 Emptying the Dishwasher
- 24 Care and Cleaning
- 25 Cleaning the Filter
- 26 What to do, if ...
- 26 ...Error messages
- 27 ...there are problems with the operation of the dishwasher
- 27 ...the wash results are not satisfactory
- 28 Technical Data
- 29 Notes for Test Institutes
- 30 Installing the Dishwasher
- 31 Dishwashers That Can Be Integrated
- 32 Connecting the Dishwasher
- 32 Water Connection
- 32 Permitted water pressure
- 32 Connect the inlet hose
- 33 Water drain
- 34 Leak Prevention System
- 35 Electrical Connection
- 36 Connections