Bar) Pins. Exmark Frontrunner Series, Frontrunner FR27KC, 720000 & Higher, Frontrunner FR31BV, 000 & Higher Serial Nos., Frontrunner 720,000 & Higher Serial Nos., Frontrunner FR23KC

Add to my manuals
44 Pages

advertisement

Bar) Pins. Exmark Frontrunner Series, Frontrunner FR27KC, 720000 & Higher, Frontrunner FR31BV, 000 & Higher Serial Nos., Frontrunner 720,000 & Higher Serial Nos., Frontrunner FR23KC | Manualzz

Maintenance

Note: If machine does not pass any of these tests,

Do Not operate. Contact your authorized EXMARK

SERVICE DEALER.

Important: It is essential that operator safety mechanisms be connected and in proper operating condition prior to use for mowing.

Check Rollover Protections

Systems (Roll Bar) Pins

Service Interval: Before each use or daily

Make sure latch pin and hair pin are fully installed and lanyard is in good condition.

Check Seat Belt

Service Interval: Before each use or daily

Visually inspect seat belt for wear, cuts, and proper operation of retractor and buckle. Replace before operating if damaged.

B. Remove paper element. Check the condition of the paper element. Replace if dirty, bent or damaged.

C. Check the condition of the inner element.

Replace whenever it appears dirty, typically every other time the paper element is replaced. Clean the base around the inner element before removing, so dirt does not get into the engine.

D. Do Not wash or use pressurized air to clean paper element or inner element.

E. Reinstall elements. Position the cover so that the rubber dust ejector is pointing downward and secure with retaining clips.

• For 23 HP Kohler Units:

A. Remove foam pre-cleaner element and wash in warm water with detergent. Rinse until all traces of detergent are eliminated and squeeze out excess water (Do Not

wring). Air dry. Saturate with engine oil and squeeze out excess oil.

B. Check paper element. Do Not wash or use pressurized air to clean paper element.

Replace if dirty, bent or damaged.

C. Reinstall foam pre-cleaner to paper element, then reinstall paper element and cover.

Check for Loose Hardware

Service Interval: Before each use or daily

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Visually inspect machine for any loose hardware or any other possible problem. Tighten hardware or correct the problem before operating.

Service Air Cleaner

Service Interval: Every 50 hours (May need more often under severe conditions. See the Engine Owner’s

Manual for additional information.)

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Tilt seat forward and raise hood to gain access to the air cleaner.

• For 27HP Kohler & 31HP Briggs & Stratton

Units:

A. Loosen retaining clips and remove air cleaner compartment cover.

Change Engine Oil

Service Interval: After the first 5 hours

Every 100 hours/Yearly

(whichever comes first)

(May need more often under severe conditions.)

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Tilt seat forward and raise hood to gain access to the engine area.

3. Drain oil while engine is warm from operation.

4. Fit hose in literature pack over oil drain valve.

Rotate the valve 1/4 counterclockwise and gently pull outward to open the valve. Allow the oil to drain, then close the valve by pushing inward and rotating 1/4 turn clockwise. Remove and retain the hose for future use.

26

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals