Check Condition Of Belts. Exmark Frontrunner Series, Frontrunner FR27KC, 720000 & Higher, Frontrunner FR31BV, 000 & Higher Serial Nos., Frontrunner 720,000 & Higher Serial Nos., Frontrunner FR23KC

Add to my manuals
44 Pages

advertisement

Check Condition Of Belts. Exmark Frontrunner Series, Frontrunner FR27KC, 720000 & Higher, Frontrunner FR31BV, 000 & Higher Serial Nos., Frontrunner 720,000 & Higher Serial Nos., Frontrunner FR23KC | Manualzz

Maintenance

Check Condition Of Belts

Service Interval: Every 40 hours

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Check pump and PTO drive belts.

3. Belts are spring tensioned and no adjustment is necessary. See Pump Drive Belt Tension and

Replacement sections in Adjustments.

Lubricate Grease Fittings

Note: See chart for service intervals.

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Lubricate fittings with one to two pumps of

NGLI grade #2 multi-purpose gun grease.

Refer to the following chart for fitting locations and lubrication schedule.

Lubrication Chart

Fitting

Locations

1. Hitch and Cylinder

Pivots

2. Fold

Pivot Pin

3. Fold

Lock Pin

4. Rear

Caster Pivot

5. Belt

Idlers

6. Motion

Control

Pivots

7. Transfer

Spring Ends

8. Dual

Tail Wheel

Pivot (if applicable)

Initial

Pumps

2

2

2

*0

1

1

1

2

Number of

Places

4

2

2

1

2

2

4

1

Service

Interval

40 Hours

100 Hours

Yearly

*Yearly

Yearly

Yearly

Yearly

40 Hours

* See step 3 for special lubrication instructions

on the rear caster pivots and the Lubricate Rear

Caster Wheel Hub section for special lubrication instructions on the rear casters wheel hub.

3. Lubricate front caster pivots once a year. Remove hex plug and cap. Thread grease zerk in hole and pump with grease until it oozes out around top bearing. Remove grease zerk and thread plug back in. Place cap back on.

Lubricate Rear Caster Wheel

Hub(s)

Service Interval: Yearly

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

1.

Seal guard

Figure 10

2.

Spacer nut with wrench flats

2. Remove caster wheel from caster forks.

3. Remove seal guards from the wheel hub.

4. Remove one of the spacer nuts from the axle assembly in the caster wheel. Note that thread locking adhesive has been applied to lock the

28

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals