Specifications. Exmark TTS16KA483CA, TTS16KA363CA, TTS20KAE483, TTS18KA523, TTS16KA363, TTS20KAE523, TTS16KA483, TTS20KAE483CA

Add to my manuals
48 Pages

advertisement

Specifications. Exmark TTS16KA483CA, TTS16KA363CA, TTS20KAE483, TTS18KA523, TTS16KA363, TTS20KAE523, TTS16KA483, TTS20KAE483CA | Manualzz

Specifications

Specifications

Model Numbers

Serial Nos: 920,000 and Higher

Manual Start Models: TTS16KA363; TTS16KA363CA; TTS16KA483; TTS16KA483CA; TTS18KA523

Electric Start Models: TTS20KAE483; TTS20KAE483CA; TTS20KAE523

Systems

Engine

• Engine Specifications: See your Engine Owner’s

Manual

• Engine Oil Type: Exmark 4–Cycle Premium

Engine Oil

• RPM: Full Speed: 3600 (No Load)

Idle: 1550 RPM

Fuel System

• Capacity: 5.0 gal. (18.9 L)

• Type of Fuel: Regular unleaded gasoline, 87 octane or higher; containing no more than 10% methanol or ethanol.

• Fuel Filter: Replaceable In-line

• Fuel Shut-Off Valve: 1/4 turn increments

Electrical System (Electric Start)

• Charging System: Flywheel Alternator

• Charging Capacity: 15 amps

• Battery Type: BCI Group U1

• Battery Voltage: 12 Volt

• Polarity: Negative Ground

• Fuses: Two 20 amp blade type

Safety Interlock System:

• Operator must have OPC (Operator Presence

Control) levers held in contact with handle grips, speed control lever in neutral, and PTO disengaged to start engine. Release of OPC levers will cause the engine to stop if speed control lever is not in neutral and/or PTO is engaged.

• Park brake must be disengaged to move speed control out of neutral or engine will kill.

Operator Controls

Steering Control: Fingertip drive control levers provide independent speed control, braking and neutral to each drive wheel for moving forward or reverse, stopping, and power turning.

Transmission

Twin Hydrostatic Drive

• Two Hydro Gear variable displacement high efficiency pumps independently coupled to two high efficiency Parker/Ross wheel drive motors.

• Hydraulic Oil: Use Exmark Premium Hydro Oil.

• Hydraulic Oil Capacity: 2.4 qt. (2.2 L)

• Hydraulic Filter is replaceable cartridge type.

P/N 109-4180: 25 microns, 10 psi bypass

(Summer use above 32°F (0°C))

P/N 1-523541: 40 microns, 18 psi bypass (Winter use below 32°F (0°C))

• Speeds:

– 0-6.2 mph (10.0 km/hr) forward.

– 0-2.2 mph (3.5 km/hr) reverse.

• Drive wheels release valves allow machine to be moved when engine is not running.

Wheel Drive System

Drive wheels are direct coupled to Parker wheel drive motors with 1 inch (25.4 mm) tapered shaft.

14

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals