KV-32S65/35S65
SECTION 2
DISASSEMBLY
2-1. REAR COVER REMOVAL
(KV-32S65)
1
Twelve Screws
(BVTP 4x16)
(KV-35S65)
1
Ten Screws
(BVTP 4x16)
2
Two Screws
(BVTP 3x12)
2-2. CHASSIS ASSEMBLY REMOVAL
1
Claw
2
Three Screws
(BVTP 3x12)
3
G Board
2
Chassis Assembly
— 9 —
KV-32S65/35S65
2-3. SERVICE POSITION
2
G Board
1
A Board
ANODE-CAP REMOVAL
WARNING: High voltage remains in the CRT even after the power is disconnected. To avoid electrical shock, discharge CRT before attempting to remove the anode cap. Short between anode and coated earth ground strap of CRT.
NOTE: After removing the anode, short circuit the anode of the picture tube and the anode cap to either the metal chassis, CRT shield or carbon painted on the CRT.
REMOVAL PROCEDURES
Turn up one side of the rubber cap in the direction indicated by arrow .
Use your thumb to pull the rubber cap firmly in the direction indicated by arrow .
HOW TO HANDLE AN ANODE-CAP
Do not use sharp objects which may cause damage to the surface of the anode-cap.
Do not squeeze the rubber covering too hard to avoid damaging the anode-cap. A material fitting called a shatter-hook terminal is built into the rubber.
Do not force turn the foot of the rubber cover. This may cause the shatter-hook terminal to protrude and damage the rubber.
— 10 —
When one side of the rubber cap separates from the anode button, the anodecap can be removed by turning the rubber cap and pulling it in the direction of arrow .
KV-32S65/35S65
2-4-1. PICTURE TUBE REMOVAL
(KV-32S65)
WARNING -- Before removing anode cap:
High voltage remains in the CRT even after the power is disconnected.
To avoid electrical shock, discharge CRT before attempting to remove the anode cap. Short between anode and coated earth ground strap of CRT.
Four screws
(Tapping screw 7)
Picture tube shield assy
C board
Neck assy
Deflection yoke
G board
Chassis
Picture tube
Anode cap
Coated earth ground strap
2-4-2. PICTURE TUBE REMOVAL
(KV-35S65)
WARNING -- Before removing anode cap:
High voltage remains in the CRT even after the power is disconnected.
To avoid electrical shock, discharge CRT before attempting to remove the anode cap. Short between anode and coated earth ground strap of CRT.
Degaussing coil
C board
Neck assy
Deflection yoke
Two Degaussing
coil holders
Four screw
(Tapping screw )
Anode cap
Coated earth ground strap
Cushion
G board
Chassis assy
Tension spring(B)
Claw
Two Degaussing
coil holders
Picture tube
Cushion
— 11 —
