1.1 Defi nitions. Ohio Medical Push-To-Set Continuous Vacuum Regulator

Below you will find brief information for Vacuum Regulator Push-To-Set Continuous Vacuum Regulator. The Push-To-Set Continuous Vacuum Regulator is a lightweight, compact unit used throughout the hospital primarily for pharyngeal/tracheal suctioning (airway management). Various models provide regulated or full-line vacuum for hospital suction procedures.

1/Precautions

Defi nitions

Note: A Note provides additional information to clarify a point in the text.

Important: An Important statement is similar to a note but of greater emphasis.

CAUTION: A CAUTION statement is used when the possibility of damage to the equipment exists.

WARNING: A WARNING statement is used when the possibility of injury to the patient or the operator exists.

MAX

High Flow

High Vacuum

High Flow

Low Vacuum

I (On)

O (Off)

= maximum

= high fl ow, high vacuum

= high fl ow, low vacuum

= on

= off

Abbreviations Used In This Manual

CCW

CVR

MAX in Hg kPa

LPM mm Hg

Continuous Vacuum Regulator

Full Line Vacuum

Inches of mercury

Kilo pascals (kPa x 7.50 = mm Hg)

Liters per minute

Millimeters of mercury (mm Hg x .133 = kPa)

°C Degrees

°F Degrees

N-m ft-lb

Newton-Meter (N-m x .737 = ft-lb)

Foot-Pound Force (ft-lb x 1.356 = N-m) oz Ounces

DISS Diameter Index Safety System

OES

NCG

NPT

NPTF

National Compressed Gases (Chemetron)

National Pipe Thread (USA)

National Pipe Thread Female (USA)

MPTS gal Gallon

PTFE Tefl on®

PTS Push-To-Set

1 8700-0006-000 Rev.3

Key Features

Lightweight and compact
Provides regulated or full-line vacuum
Includes vacuum gauge
Features positive pressure safety relief valve
Low models have vacuum relief valve to limit maximum suction
Operates in regulated or non-regulated mode
Automatically adjusts suction level
Easy to use and adjust
Safe and reliable

Frequently Answers and Questions

What is the purpose of the Push-To-Set Continuous Vacuum Regulator?

The Push-To-Set Continuous Vacuum Regulator is used to provide suction for various medical procedures, primarily for pharyngeal/tracheal suctioning (airway management).

How do I set the suction level on the Push-To-Set Continuous Vacuum Regulator?

To set the suction level, turn the mode selector switch to "I" (On) and rotate the suction control knob until the vacuum gauge indicates the desired setting.

What is the difference between the regulated and non-regulated modes on the Push-To-Set Continuous Vacuum Regulator?

In the non-regulated (MAX) mode, the vacuum source is connected directly to the fitting port, providing full-line vacuum. In the regulated mode, the vacuum source is connected through the regulator module, which functions as an automatic valve to control the suction level.

How do I clean the Push-To-Set Continuous Vacuum Regulator?

Routine cleaning is recommended after each use. Wipe all exterior surfaces with a solution of water and mild detergent. If the regulator becomes flooded with patient fluid, all internal components (except the gauge) can be cleaned with a solution of warm water and mild detergent. Dry all components thoroughly before assembly.