Installation Manual

red

VARIOMATIC

USE AND INSTALLATION MANUAL

Chapter

3

page. 10

 

3. TECHNICAL SPECIFICATIONS AND DIMENSIONS

3.1. Technical specifications

The Variomatic mod. heat generator is a steel boiler fuelled by wood pellets with a vacuum combustion chamber.

 Heat exchanger welded with steel plates to heat the water in the circuit

 Combustion gas fan

 Fresh air supply fan

 Mechanism to remove ash from the burner - removes ash residues from the burner grille

 Hopper for daily fuel with a capacity of approximately 130 kg.

 Programmable operating module that controls the operation of the appliance. This module can be adjusted to the specific requirements of the individual heating system as well as for the characteristics of the fuels.

 Container for ash residues with a capacity of approximately 5 kg.

 Semi-automatic, manually enabled system for ash removal (this system removes ash deposited on the inner surfaces of the pipes in the connective sections of the boiler)

 Automatic fuel ignition system

 Automatic system for removing ash from the burner

 Automatic system with fuel supply auger

 Automatic operation of the appliance. The hot water boiler can be connected to a programmable room thermostat that guarantees maximum heat comfort and reduced fuel consumption.

 The appliance uses solid biomasses in the form of pellets (wood pellets) as fuel. The ash content of these pellets is above the limits defined by the following standards: ENplus (EN 14961-2:2010),

ONORM M7135, DIN 51731 DINPlus.

 High efficiency.

 Low content of polluting agents in the combustion gasses.

 The operating control module can activate the operation of an additional, external fuel supply system that feeds the fuel from an external hopper to the relevant integrated hopper.

 Maintenance and very simple servicing procedures.

 Low management costs.

 

Technical specifications Technical dept. - All rights reserved - Reproduction prohibited