Stylitis-4x User Manual 02/05

APPENDIX B

Press any key for main menu.

1>STATUS2>SETUP3>DISPLAY

4>SERIAL LOAD 5>ACQ on/off

1

To see system status.

2

To set system parameters.

3

To display inputs

(1)

4

To download buffer-data via

RS232 to PC.

5

To Start or Stop acquisition

(recording) of data.

To accept press [ENTER].

STYLITIS-41 MENU TREE

STATUS: 1>INFO 2>BAT

3>CARD 4>BUF 5>ACTIVITY

5>ACTIVITY

1

To check Software version.

2

To check battery voltage.

3

To get card type and free

space. To clear card.

4

To get internal buffer free space.

5

To check system current activity:



ACQuisition ON or OFF



Averaging Interval (INT xx')



Storage medium.

SETUP:1>RATE2>IN 3>MODE

4>SITE 5>TIME 6>PASSWORD

1

To select averaging interval.

(1)

2

To setup input parameters.

3

To select continuous or energysave operation.

4

To give a site name

(alphanumeric)

(5)

.

5

To set time and date.

6

To set the password.

1>ANALOG 2>COUNTER3>TYPE

1

2

To setup vane and analog input parameters.

Select an input, 1-4.

Then use

[



] or [



] to select option:



Not used



Vane input

(2)



Analog input slope & offset

(3)

To setup anemometer and counter parameters.

Select an input, 1-3. Then use [



] or [



] to select option:



Not used



Anemometer slope, offset

(3)



Frequency counter



Event counter

3

To select C1, C2, C3 input signal type:

(4)



SIN for low-level AC source.



TTL for digital source.



To select a menu item use the corresponding numeric key.



[ESC] goes one menu-level up and abandons changes.



[ENTER] goes one menu-level up and saves changes.



You can change parameters only if ACQUISITION is OFF.

NOTES:

(1)

Use [



] or [



] to select.

(2)

Use [

—] to select vane zero point.

(3)

Use [1] or [2] to select fields.

(4)

Press corresponding numeric key to change anem or counter type between Low Level AC (SIN) and Digital (TTL).

(5)

Press [.] to use numerals as letters.

STYLITIS -41 USER'S MANUAL

29