Pocket Pump 210-1000 Operating Instructions 37717 PDF Document

Add to my manuals
33 Pages

advertisement

Pocket Pump 210-1000 Operating Instructions 37717 PDF Document | Manualzz

Battery Care and Maintenance

Replacing the Battery Pack

▲ ✳

FLOW

mL/min

1. Press down on the sliding keypad cover near the SKC logo with your thumb, and push the keypad cover down and away from the display until it is free from the pump.

2. Lay the pump on a flat surface with the LCD facing upwards. Remove the two screws on the front panel of the pump.

3. Turn the pump over so that the LCD faces down. Remove the belt clip by unscrewing the single locking screw, and remove the battery compartment cover.

The use of a repaired or rebuilt battery pack voids the SKC warranty and the

UL Intrinsic Safety Listing.

18

Battery Care and Maintenance

4.

Unplug the old battery pack by carefully lifting it upwards, and remove it from the pump.

5.

Plug in the replacement battery pack. Replace the battery compartment cover and belt clip.

6.

Turn the pump over so that the LCD faces upwards. Replace the two screws on the front panel of the pump (do not overtighten the screws) and replace the keypad cover.

7.

Charge the new battery pack (see page 21).

min

Do not charge or operate the pump with the charger in hazardous atmospheres!

Use only SKC-approved charger and battery pack designated for the Pocket

Pump to ensure reliable performance and intrinsic safety and to maintain the

SKC warranty.

19

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals