02/03/08 18:55:28 32KHA600_043

ESSENTIAL INDIVIDUAL COMPONENTS

IGNITION SWITCH

The ignition switch ( ) is below the indicator panel.

1

LOCK

OFF

ON

Key Position

LOCK

(steering lock)

OFF

ON

(1)

(1) Ignition switch

Function

Steering is locked. Engine and lights cannot be operated.

Engine and lights cannot be operated.

Engine and lights can be operated.

Key Removal

Key can be removed

Key can be removed

Key cannot be removed

33

02/03/08 18:55:36 32KHA600_044

RIGHT HANDLEBAR CONTROLS

Engine Stop Switch

1 throttle grip. When the switch is in the

(RUN) position, the engine will operate.

When the switch is in the (OFF) position, the engine will not operate. This switch is intended primarily as a safety or emergency switch and should normally remain in the (RUN) position.

Starter Button

The starter button ( ) is below the engine stop switch ( ).

When the starter button is pressed, the starter motor cranks the engine. If the engine stop switch is in the (OFF) position, the starter motor will not operate.

See page 42 for the starting procedure.

(1)

(1) Engine stop switch

(2) Starter button

(2)

34

02/03/08 18:55:47 32KHA600_045

LEFT HANDLEBAR CONTROLS

The headlight switch ( ) has two positions; and OFF marked by a dot under the

.

1

OFF(dot):

: Headlight, taillight and meter lights on.

Headlight, taillight and meter lights off.

Push the dimmer switch to select high beam or to low beam.

(HI) to

(LO) to select

Move to (L) to signal a lef t turn,

(R) to signal a right turn. Press to turn signal off.

4

Press the button to sound the horn.

(1)

(3)

(4)

(1) Headlight switch

(2) Headlight dimmer switch

(3) Turn signal switch

(4) Horn button

(2)

35

02/03/08 18:55:52 32KHA600_046

FEATURES

(Not required for operation)

STEERING LOCK

To lock the steering, turn the handlebars all

1 to LOCK while pushing in. Remove the key.

Do not turn the key to LOCK while riding the motorcycle; loss of vehicle control will result.

(B)

(A)

(1)

(1) Ignition key (A) Push in

(B) Turn to LOCK

36

02/03/08 18:55:58 32KHA600_047

SIDE COVER

The right side cover must be removed for battery and fuse maintenance.

The left side cover must be removed for air cleaner maintenance

Removal:

1.

2.

Remove the bolt (1).

Pull out the side cover (2).

Installation:

Installation can be done in the reverse order of removal.

(1) Bolt

(2) Side cover

(2)

(1)

37

02/03/08 18:56:02 32KHA600_048

TOOL BAG STORAGE

The tool bag (1) and owners manual (2) is in the tool box storage (3) under the rear fender.

(3)

(1) Tool bag

(2) Owners manual

(3) Tool box storage

(2)

(1)

38

02/03/08 18:56:07 32KHA600_049

H E A D L I G H T A I M V E R T I C A L

ADJUSTMENT

Vertical adjustment can be made by turning the screw ( ) in or out as necessary.

Obey local laws and regulations.

( A )

(1) Screw

( B )

(1)

(A) Up

(B) Down

39