HP LaserJet P2015 Series

Pickup and feed assemblies

This section covers the major assemblies of the pickup and feed system: the transfer roller and the registration assembly.

Transfer roller

NOTE

It is important to make sure that the transfer roller needs to be replaced before removing it. Excess handling can cause additional damage.

1.

Open the print-cartridge door and remove the print cartridge.

2.

Use needle-nose pliers to release the transfer roller tabs at the end of the roller, near the right side of the printer.

CAUTION

Do not break the tabs, and do not touch the rollers.

Figure 6-43

Removing the transfer roller

3.

Lift up the end of the roller near the right side of the printer, and then slide it toward the right side of the printer while pulling it out of the printer.

128 Chapter 6 Removal and replacement ENWW