ADVR-0410H1M, ADVR-0820H2M, ADVR-1640H2M Digital Video Recorder User Manual
Below you will find brief information for Digital Video Recorder ADVR-0410H1M, Digital Video Recorder ADVR-0820H2M, Digital Video Recorder ADVR-1640H2M. This user manual describes how to install, configure, and operate the device, including live view, recording, playback, alarm settings, network settings, HDD management, camera settings, device management and maintenance, and other features. The manual also provides user tips and troubleshooting advice for common issues. It is recommended to read the user manual carefully before starting to use the device.
advertisement
User Manual of Digital Video Recorder
1.5 Rear Panel
ADVR:
The rear panels of ADVR are shown in Figure 1.5, Figure 1.6 and Figure 1.7.
1
Figure 1.4 Rear Panel of ADVR-0410H1M
2 6
11
3 4 5 7 8 9 10
12
Figure 1.5 Rear Panel of ADVR-1640H2M
Note:
The rear panel of ADVR-0820H2M provides 8 video input interfaces.
Table 1.5 Description of Rear Panel
4
5
6
7
No.
1
2
3
8
9
10
11
12
Item
VIDEO IN
VIDEO OUT
USB Interface
HDMI
VGA
AUDIO IN
AUDIO OUT
LAN Interface
RS-485 Interface
12V
POWER
GND
Description
BNC connector for analog video input.
BNC connector for video output.
Connects USB mouse or USB flash memory devices.
HDMI video output.
DB15 connector for VGA output. Display local video output and menu.
RCA connector for audio input.
RCA connector for audio output.
RJ45 10M/100M Ethernet interface.
Connector for RS-485 devices. Connect the D+ and D- terminals to T+ and T- of PTZ receiver respectively.
12VDC power supply.
Switch for turning on/off the device.
Ground (needs to be connected when DVR starts up).
1.6 Starting Up and Shutting Down the Device
Purpose:
Proper startup and shutdown procedures are crucial to expanding the life of the device.
Before you start:
Check that the voltage of the extra power supply is the same with the device’s requirement, and the ground connection is working properly.
Starting up the device:
16
User Manual of Digital Video Recorder
Steps:
1. Check the power supply is plugged into an electrical outlet. It is HIGHLY recommended that an
Uninterruptible Power Supply (UPS) be used in conjunction with the device.
2. Press the POWER button on the rear panel. The Power indicator LED should turn green indicating that the unit begins to start up.
Shutting down the device:
Steps:
1. Enter the Shutdown menu.
Menu > Shutdown
Figure 1.6 Shutdown Menu
2. Click the Shutdown button to enter the following dialog box:
Figure 1.7 Dialog Box for Shutdown
3. Click the Yes button. The following message box pops up:
Figure 1.8 Message Box for Power Off
4. Turn off the power switch on the rear panel of DVR.
Rebooting the device
In the Shutdown menu (Figure 1.11), you can also click Reboot to reboot the device.
17
advertisement
Key Features
- PAL/NTSC adaptive video inputs
- H.264 video compression
- Encoding at up to WD1 resolution
- Dual-stream support per channel
- Independent configuration for each channel
- Motion detection alarm
- Multiple PTZ protocols supported
- Remote control and monitoring
- Backup to USB, SATA, or eSATA
- Embedded Web server
