ADVR-0410H1M, ADVR-0820H2M, ADVR-1640H2M Digital Video Recorder User Manual
Below you will find brief information for Digital Video Recorder ADVR-0410H1M, Digital Video Recorder ADVR-0820H2M, Digital Video Recorder ADVR-1640H2M. This user manual describes how to install, configure, and operate the device, including live view, recording, playback, alarm settings, network settings, HDD management, camera settings, device management and maintenance, and other features. The manual also provides user tips and troubleshooting advice for common issues. It is recommended to read the user manual carefully before starting to use the device.
advertisement
User Manual of Digital Video Recorder
C H A P T E R 2
Getting Started
18
User Manual of Digital Video Recorder
The Setup Wizard can walk you through some important settings of the device. By default, the Setup Wizard starts once the device has loaded.
Operating the Setup Wizard:
1.
Select the system resolution from the drop-down menu. The default resolution is 1280×1024/60Hz.
Click Apply to save the resolution settings.
Figure 2.1 Start Wizard Interface
Notes:
1. By default, the system resolution is set to 1280×1024.
2.
Check the checkbox to enable Setup Wizard when device starts. Click Next to continue the setup wizard.
You can also click Cancel to exit the Setup Wizard, or use the Setup Wizard next time by leaving the
“Start wizard when DVR starts?” checkbox checked and exit.
Figure 2.2 Start Wizard Interface
3.
Click Next button on the Wizard window to enter the Login window, as shown in Figure 2.3.
1) Enter the admin password. By default, the password is 12345.
2) To change the admin password, check the New Admin Password checkbox. Enter the new
19
User Manual of Digital Video Recorder password and confirm the password in the given fields.
Figure 2.3 Login Window
4.
Click the Next button to enter the Date and Time settings window, as shown in Figure 2.4.
Set the time zone, date format, system date and system time.
Figure 2.4 Date and Time Settings
5.
Click Next button which takes you back to the Network Setup Wizard window, as shown in Figure 2.5.
Set the network parameters, including the NIC type, IPv4 address, IPv4 subnet mask, default gateway, etc. You can enable the DHCP to automatically obtain an IP address and other network settings from that server.
20
User Manual of Digital Video Recorder
Figure 2.5 Network Configuration
Note:
The ADVR provide one 10M/100Mbps self-adaptive network interface.
6.
Click Next button to enter the HDD Management window, shown in Figure 2.6.
To initialize the HDD, click the Init button. Initialization removes all the data saved in the HDD.
Figure 2.6 HDD Management
7.
Click Next button to enter the Record Settings window, as shown in Figure 2.7.
1) Select the camera to configure.
2) Check the checkbox to enable Start Recording.
3) Select the recording mode to Normal or Motion Detection.
21
User Manual of Digital Video Recorder
Figure 2.7 Record Settings
4) Click Copy to copy the record settings of the current camera to other camera (s) if needed, as shown in Figure 2.8.
Figure 2.8 Copy Record Settings
5) Click OK to return to the Record Settings window.
8.
Click OK to complete the startup Setup Wizard.
22
advertisement
Key Features
- PAL/NTSC adaptive video inputs
- H.264 video compression
- Encoding at up to WD1 resolution
- Dual-stream support per channel
- Independent configuration for each channel
- Motion detection alarm
- Multiple PTZ protocols supported
- Remote control and monitoring
- Backup to USB, SATA, or eSATA
- Embedded Web server
