ADVR-0410H1M, ADVR-0820H2M, ADVR-1640H2M Digital Video Recorder User Manual
Below you will find brief information for Digital Video Recorder ADVR-0410H1M, Digital Video Recorder ADVR-0820H2M, Digital Video Recorder ADVR-1640H2M. This user manual describes how to install, configure, and operate the device, including live view, recording, playback, alarm settings, network settings, HDD management, camera settings, device management and maintenance, and other features. The manual also provides user tips and troubleshooting advice for common issues. It is recommended to read the user manual carefully before starting to use the device.
advertisement
User Manual of Digital Video Recorder
3.3 Adjusting Live View Settings
Purpose:
Live View settings can be customized according to different needs. You can configure the output interface, dwell time for screen to be shown, mute or turning on the audio, the screen number for each channel, etc.
Steps:
1. Enter the Live View Settings interface.
Menu> Configuration> Live View
Figure 3.8 Live View-General
The settings available in this menu include:
•
Video Output Interface: Select the output to configure the settings for. The following interfaces are selectable: VGA/HDMI, Main CVBS and Spot Output 1.
Note:
Up to 16-division window display is supported for the CVBS output.
•
Dwell Time: The duration between switching of channels when enabling auto-switch in Live
View.
•
Enable Audio Output: Enable/disable audio output for the selected video output.
Notes:
1. When the VGA/HDMI output interface is used as the main video output and the Audio
Output for the VGA/HDMI output interface is enabled, the VGA/HDMI audio and
AUDIO OUT can be used for live view, playback and two-way audio.
2. When the VGA/HDMI output is used as the main video output and the Audio Output for the VGA/HDMI output interface is disabled, the VGA/HDMI output provides no audio and the AUDIO OUT is used for two-way audio.
3. When the CVBS output is used as the main video output, the VGA/HDMI audio is provided for Aux video output in live view, and the AUDIO OUT is used as the main video output(for live view, playback or two-way audio).
•
Event Output: Select the output to show event video. The following interfaces are selectable:
VGA/HDMI, Main CVBS and Spot Output 1.
•
Full Screen Monitoring Dwell Time: The time in seconds to show alarm event screen.
2. Setting Camera Order
30
User Manual of Digital Video Recorder
Figure 3.9 Live View- Camera Order
To set the camera order:
1) Click the View tab to enter the camera order settings interface.
2) Select an output interface and select a screen layout.
3) Click to select a screen in the right region and double-click to select a channel in the left region.
Thus the selected channel will be displayed in the corresponding screen.
Note:
means the channel will not be displayed.
4) You can click to start live view of all channels and click to stop live view of all channels.
Click or to go to the previous or next page.
5) Click the Apply button to save the setting.
31
advertisement
Key Features
- PAL/NTSC adaptive video inputs
- H.264 video compression
- Encoding at up to WD1 resolution
- Dual-stream support per channel
- Independent configuration for each channel
- Motion detection alarm
- Multiple PTZ protocols supported
- Remote control and monitoring
- Backup to USB, SATA, or eSATA
- Embedded Web server
