ADVR-0410H1M, ADVR-0820H2M, ADVR-1640H2M Digital Video Recorder User Manual
Below you will find brief information for Digital Video Recorder ADVR-0410H1M, Digital Video Recorder ADVR-0820H2M, Digital Video Recorder ADVR-1640H2M. This user manual describes how to install, configure, and operate the device, including live view, recording, playback, alarm settings, network settings, HDD management, camera settings, device management and maintenance, and other features. The manual also provides user tips and troubleshooting advice for common issues. It is recommended to read the user manual carefully before starting to use the device.
advertisement
User Manual of Digital Video Recorder
10.4 Configuring Quota Mode
Purpose
Each camera can be configured with allocated quota for the storage of recorded files.
Steps
1.
Enter the Storage Mode interface.
Menu > HDD > Advanced
2.
Set the Mode to Quota.
Note:
The device must be rebooted to enable the changes to take effect.
Figure 10.14 Storage Mode Settings Interface
3.
Enter the storage capacity in the text field of Max. Record Capacity (GB).
Figure 10.15 Configure Record Quota
4.
You can copy the quota settings of the current camera to other cameras if required. Click the Copy button to enter the Copy Camera menu, as shown below.
Figure 10.16 Copy Settings to Other Camera(s)
5.
Select the camera (s) to be configured with the same quota settings. You can also click the checkbox of
138
User Manual of Digital Video Recorder
Analog to select all cameras.
6.
Click the OK button to finish the Copy settings and back to the Storage Mode interface.
7.
Click the Apply button to apply the settings.
Note:
If the quota capacity is set to 0, then all cameras will use the total capacity of HDD for recording.
139
advertisement
Key Features
- PAL/NTSC adaptive video inputs
- H.264 video compression
- Encoding at up to WD1 resolution
- Dual-stream support per channel
- Independent configuration for each channel
- Motion detection alarm
- Multiple PTZ protocols supported
- Remote control and monitoring
- Backup to USB, SATA, or eSATA
- Embedded Web server
