Updating a Jukebox on Location with the USB Content Updater. TouchTunes Jukebox

Locating Music and Sending it to Jukeboxes Using the Dashboard recognize the update. This means the files on your USB device must not be located in any folder or subfolder on the USB device.

Figure 36 The right way and wrong way to store the update package on a USB device

Updating a Jukebox on Location with the USB Content Updater

Once you have created an update package on a USB key, you are ready to bring that key to your locations, and transfer the content to your jukebox or jukeboxes.

Note: The USB Content Updater is compatible with Gen 3 jukeboxes running Gen 3 software

release 3.3.1 or higher. If your jukebox is running software older than this release, you will need to contact TouchTunes Technical Support about updating your jukebox for you. Once your software has been updated, you will be able to use the USB Content Updater for any future software upgrades.

To update your jukeboxes using your USB device:

1. Open your jukebox so you can access its USB ports.

The USB ports are located on the jukebox’s MJS or JCB unit, the main hardware component within your jukebox that houses its hard drive and CPU. You can use any of the available USB slots for the connection.

76

Updating a Jukebox on Location with the USB Content Updater

2. With the jukebox powered on and displaying the main album selection screen (below), plug the USB device into a USB port.

Figure 37 The main customer screen on a Gen 3 jukebox

77