V8plus Body Shaping System User Manual

3.6 Operation Procedure

Note：Default handpiece is handpiece 1;

The following procedure is taking treatment on back for example.

Interface of main menu: After initialization, the system enters main interface（Picture 11）

Interface of main operation：Press A in picture 11 and the system enters main operation interface(picture 12)

Picture 11 (main menu)

 A in picture 12：

This part shows treatment manner on human body;

Press “ ” to stop it; Press “ ” to start it.

Picture 12 (main operation)

 B in picture 12：

Handpiece selection：Press handpiece you want and E in picture 12 would show it;

To set working time：In main operation interface (default working time is 20 minutes):

Press “ ” and it turns green;

Press “＋” or “-” in E to adjust it (adjustment scope: 0-60 minutes, 1 minute/press)

 C in picture 12：

To adjust energy of infrared laser：

In main operation interface, Press “

Press “＋” or “-” in E to adjust it.

”，the parameter would turns green;

To adjust output RF energy：

Press “ ” and the parameter would turns green;

Press “＋” or “-” in E to adjust it.

To adjust speed of roller：

Press “ ” and the parameter would turns green;

Press “＋” or “-” in E to adjust it.

 D in picture 12：

12

To adjust vacuum：

Press “ ” and the parameter would turns green;

Press “＋” or “-” in E to adjust it.

To set duration of pulse:

Press “ ” and the parameter would turns green;

Press “＋” or “-” in E to adjust it.

To enter standby situation:

Directly press “Ready” key to enter standby situation. Indicator light of selected handpiece is illuminated.

To enter working situation: Press A in picture 13 or step on footswitch;

To exit working situation: Press A in picture 13 or step on footswitch;

To enter standby situation:

Under ready situation, press “Standby” key. Indicator light of selected handpiece goes off.

Picture 13

To exit main operation interface：In main menu interface, press “ ” .

Picture 14 Picture 15

Air pressure detection：At the beginning, it is on (A in picture 14);

Press “ ”, it is shut off (A in picture 15);

Note: If there is something wrong with air pressure, you shall shut off air pressure detection. And contact with our company.

13