HÄFTIGT Integrated fridge/freezer A+

Add to my manuals
28 Pages

advertisement

HÄFTIGT Integrated fridge/freezer A+ | Manualzz

ENGLISH 17

• regularly check the door seals and wipe clean to ensure they are clean and free from debris.

• rinse and dry thoroughly.

Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour.

Clean the condenser (black grill) and the compressor at the back of the appliance with a brush . This operation will improve the performance of the appliance and save electricity consumption.

Take care of not to damage the cooling system.

Defrosting of the refrigerator

Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops,

Troubleshooting

Warning! Refer to Safety chapters.

during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates.

It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole.

Defrosting the freezer

The freezer compartment is frost free. This means that there is no build up of frost when it is in operation, neither on the internal walls nor on the foods.

The absence of frost is due to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan.

Periods of non-operation

When the appliance is not in use for long periods, take the following precautions:

1. Remove all food.

2. Defrost, if applicable

3. Clean the appliance and all accessories.

4. Leave all doors open to prevent unpleasant smells.

If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.

ENGLISH 18

What to do if...

Problem

The appliance does not operate.

The appliance is noisy.

Audible or visual alarm is on.

The lamp does not work.

The lamp does not work.

The compressor operates continually.

Possible cause

The appliance is switched off.

The mains plug is not connected to the mains socket correctly.

There is no voltage in the mains socket.

The lamp is in stand-by.

The lamp is defective.

Solution

Switch on the appliance.

Connect the mains plug to the mains socket correctly.

The appliance is not supported properly.

The cabinet has been recently switched on or the temperature is still too high.

The temperature in the appliance is too high.

Connect a different electrical appliance to the mains socket.

Contact a qualified electrician.

Check if the appliance stands stable.

Refer to "High Temperature

Alarm".

Contact a qualified electrician or contact the nearest After

Sales Service.

Close and open the door.

Contact the nearest After

Sales Service.

Refer to "Operation" chapter.

Temperature is set incorrectly.

Many food products were put in at the same time.

The room temperature is too high.

Food products placed in the appliance were too warm.

The door is not closed correctly.

The Fast Freezing function is switched on.

Wait some hours and then check the temperature again.

Refer to climate class chart on the rating plate.

Allow food products to cool to room temperature before storing.

Refer to "Closing the door".

Refer to "Fast Freezing function".

ENGLISH 19

Problem

The compressor does not start immediately after pressing the Fast Freezing, or after changing the temperature.

The compressor does not start immediately after pressing the Shopping, or after changing the temperature.

Water flows inside the refrigerator.

Possible cause

The Shopping function is switched on.

This is normal, no error has occurred.

This is normal, no error has occurred.

The water outlet is clogged.

Food products prevent that water flows into the water collector.

Water flows on the floor.

The melting water outlet is not connected to the evaporative tray above the compressor.

Temperature cannot be set.

The Shopping function is switched on.

Solution

Refer to "Shopping function".

The compressor starts after a period of time.

The compressor starts after a period of time.

Clean the water outlet.

Make sure that food products do not touch the rear plate.

Attach the melting water outlet to the evaporative tray.

Temperature cannot be set.

The temperature in the appliance is too low/too high.

The Fast Freezing function is switched on.

The temperature regulator is not set correctly.

The door is not closed correctly.

Switch off Shopping manually, or wait until the function resets automatically to set the temperature. Refer to " Shopping function".

Switch off Fast Freezing manually, or wait until the function resets automatically to set the temperature. Refer to "Fast

Freezing function".

Set a higher/lower temperature.

Refer to "Closing the door".

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals