Preface
Purpose of This Manual
This manual describes how to install, configure and troubleshoot your
Encoder/Counter module.
For Information about:
About the Encoder/Counter Modules
See:
Chapter 1
Installing the Encoder/Counter Module
Encoder/Counter Module Input and Output
Data
Chapter 2
Chapter 3
Configuring Your Encoder/Counter Module
Chapter 4
Accessing Instantiated Instances
Troubleshooting with the Indicators
Specifications
Chapter 5
Chapter 6
Appendix A
Who Should Use This
Manual
You must be able to use RSNetworx software or similar configuration software to set up and calibrate these modules. You must have the capability to download and use Electronic Data Sheet files.
We assume you know how to do this in this manual. If you do not, refer to your software user manuals or online help before attempting to use these modules.
1
Related Products and
Documentation
The following table lists related 1734 products and documentation.
Description
POINT I/O Technical Data
Sink Input Module Installation Instructions
Source Output Module Installation Instructions
Analog Input Module Installation Instructions
Analog Output Module Installation Instructions
Relay Output Module Installation Instructions
Protected Output Module Installation Instructions
24V Very High Speed Counter Module Installation Instructions
5V Very High Speed Counter Module Installation Instruction
Cat. No.
1734-Series
1734-IB2, -IB4
1734-IV2, -IV4
1734-IE2C
1734-OE2C
1734-OW2
Publication
1734-2.1
1734-IN051
1734-IN052
1734-IN053
1734-IN054
1734-IN055
1734-OB2E, -OB4E 1734-IN056
1734-VHSC24 1734-IN003a
1734-VHSC5 1734-IN004A
Publication 1734-UM006A-EN-P - August 2000
