Legacy Platinum SCR Single Phase Charger

Add to my manuals
30 Pages

advertisement

Legacy Platinum SCR Single Phase Charger | Manualzz

4. LOCATION AND INSTALLATION

WARNING: DO NOT INSTALL THE CHARGER ON OR NEAR FLAMMABLE MATERIALS. POSITION

THE CHARGER ON A FOUNDATION OF STONE, BRICK, CONCRETE OR GROUNDED METAL.

Proper installation of the charger is important in order to achieve good performance and to prevent damage to the charger and batteries. The charger should be located in a clean, cool, dry, and well ventilated area. To permit free air flow for convection cooling, allow 4 inches (102mm) minimum between the charger and any wall, 6 inches

(152mm) from other equipment, and never store anything beneath the charger. Do not obstruct the airflow space around and beneath the charger.

Allow 36 inches (914mm) minimum clearance in front of the charger for ease of operation, maintenance, and service.

Install the charger in an area where the temperatures will remain within the range of 32ºF to 105ºF (0°C to 40°C) and the relative humidity will remain below 95 percent (%). Exceeding these ranges will reduce the current capacity and possibly the service life of the charger. If the charger will be operated outside of these ranges, contact the dealer to verify if it will withstand these conditions and perform at the needed capacity.

4.1 Horizontal Mounting

To bolt to the horizontal mounting surface, the mounting bolts will attach through the four mounting bolt slots in the bottom surface of the charger legs that are nearest the corners of the charger. The charger itself can be used as a template to mark the locations of the holes to be made in the mounting surface or the bottom mounting hole dimensions in Figure 4.1-1 can be used to measure the locations of the mounting bolt holes. www.douglasbattery.com

Figure 4.1-1: Bottom Mounting Hole Dimensions

Single Phase

8 of 30 User’s Manual

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals