Legacy Platinum SCR Single Phase Charger

Add to my manuals
30 Pages

advertisement

Legacy Platinum SCR Single Phase Charger | Manualzz

10.2 Visual Inspections

Check the charger for any physical failures, such as loose contacts or hardware, excess wear, or damage.

Darkened or hot terminals should be tightened or replaced.

10.3 Battery Conditions

Batteries must be well maintained for the charging system to operate properly. Follow battery manufacturer instructions for battery maintenance. Check for loose connections or corrosion.

CAUTION: CHECK THE DC CONNECTIONS FROM THE CHARGER TO THE BATTERY AND MAKE

SURE THEY ARE TIGHT AND CLEAN. TIGHTEN AND/OR CLEAN IF NEEDED. FAILURE TO DO SO

COULD CAUSE MALFUNCTION, FIRE, OR EXPLOSION.

DC connections may become corroded over time. If the connections become corroded, they should be cleaned as recommended by the battery manufacturer. After the connections have been cleaned, a battery connection treatment should be applied to help prevent corrosion from reoccurring. Contact the battery manufacturer for their recommendations.

Periodic cleaning and watering of non-sealed batteries is very important. Logging the water usage of nonsealed batteries is useful. As a battery ages, it will use more water.

11. TROUBLESHOOTING AND SERVICE

WARNING: USE EXTREME CAUTION WHEN WORKING INSIDE THE CHARGER OR WITH THE

CHARGING SYSTEM. DO NOT ATTEMPT TO WORK INSIDE THE CHARGER UNLESS YOU ARE A

QUALIFIED SERVICE TECHNICIAN OR ELECTRICIAN. HIGH VOLTAGES APPEAR AT SEVERAL POINTS

INSIDE THE BATTERY CHARGER. DISCONNECT AND LOCK OUT BOTH AC AND DC POWER FROM THE

CHARGER BEFORE REMOVING ANY COMPONENT. CONTACT WITH LIVE COMPONENTS WITHIN THE

CHARGER COULD CAUSE ELECTRICAL SHOCK, SERIOUS INJURY, OR DEATH.

The charger was fully tested and calibrated before leaving the factory. It was delivered ready to charge with userspecified, factory-configured amp-hour settings and battery profiles. If properly installed, the charger should require very little attention. If improper charger operation occurs, it will require repair by your dealer’s Qualified

Service Technician. CONTACT YOUR CHARGER DEALER FOR TROUBLESHOOTING AND SERVICE. www.douglasbattery.com 29 of 30 User’s Manual

NOTES

Represented By:

*38494* www.douglasbattery.com 30 of 30

38494A

User’s Manual

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals