20G211-00 E2 User Manual

20G211-00 E2 User Manual

1

Getting Started

Getting Started

This chapter gives an overview of the board and some hints for first installation in a system.

1.1

Map of the Board

Figure 1. Map of the board – front panels

G211 with 4 RJ45 G211 with 4 M12

® ®

L A

1

X1

L A

2

X2

L A

1

X1

L A

2

X2

X3

X4

L A

4

L A

3

X3

X4

L A

4

L A

3

G211 G211

MEN Mikro Elektronik GmbH

20G211-00 E2 – 2014-05-22

14

Figure 2. Map of the board with RJ45 front connectors – top view

Heat Sink

RJ45 Front

Connectors

Getting Started

Ethernet Controller CompactPCI Serial Connector P1

Figure 3. Map of the board with M12 front connectors – top view

Heat Sink

M12 Front

Connectors

MEN Mikro Elektronik GmbH

20G211-00 E2 – 2014-05-22

Ethernet Controller CompactPCI Serial Connector P1

15

Getting Started

1.2

Integrating the Board into a System

You can use the following "check list" when installing the G211 in a CompactPCI

Serial system for the first time.

 Power-down the system.

 Insert the G211 into a peripheral slot of your CompactPCI Serial system, making sure that the CompactPCI Serial connectors are properly aligned.

Note: The peripheral slots of every CompactPCI Serial system are marked by a circle on the backplane and/or at the front panel.

 Power-up the system.

 You can now install driver software.

1.3

Installing Driver Software

For a detailed description on how to install driver software please refer to the respective documentation.

You can find any driver software available for download on MEN’s website .

MEN Mikro Elektronik GmbH

20G211-00 E2 – 2014-05-22

16

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project