Figure 5-43 Initial MULTI FREQ – Run Display (from example in section 5.14.1.1). Wayne Kerr 3260B

5–40

Off Abs %

IMPEDANCE

Advanced Operation

Switches between no limits, absolute limits or percentage limits.

When set to Off, no nominal value or limits are displayed, but any previously selected values will be retained in memory.

When Abs is selected, High, Low and Minor term limits are displayed. when % is selected the Nominal value together with High, Low and Minor term limits are displayed.

The nominal and limits are set as described in the example above.

Nominal and limit values for MULTI FREQ – Set mode are independent of those set in any other mode.

Enters IMPEDANCE MODE so that measurement parameters may be set up or changed. When the correct measurement parameters are set, the RETURN soft key returns the instrument to

MULTI FREQ – Set mode.

Enters MULTI FREQ – Run mode: see section 5.14.2.

RUN

5.14.2 MULTI FREQ – Run

Before a multi-frequency test can be run it must be set up as described in section 5.14.1.

Pressing the RUN soft key from MULTI FREQ – Set mode enters MULTI FREQ – Run mode. When first entering this mode the screen will look similar to Figure 5-43 which shows

MULTI FREQ – Run mode entered after setting MULTI FREQ – Set mode according to the example in section 5.14.1.1.

Figure 5-43 Initial MULTI FREQ – Run Display (from example in section 5.14.1.1)

When the Start soft key or the Trigger key is pressed, the analyzer will measure the component at the frequencies and measurement parameters previously set and the measurement