CARE AND MAINTENANCE. Doc IT Doc IT ALL 8545-WHT-ALL, Doc IT IN 8545-WHT-IN

Doc IT ALL® & Doc IT IN®

Installation and Operation Manual

CARE AND MAINTENANCE

Item

Bag Replacement

Hose maintenance

*Motor Inlet Filter

Maintenance:

Maintenance Task

Open bottom door, remove and replace bag

Run hose out completely. Wipe thoroughly from end to end with damp cloth.

Disconnect power or turn off at household breaker.

Clean or Replace filter by removing Cover from top of motor beside Filter Bag. Slide fingers between foam and motor grill to center and snap cover off.

Frequency

Check Monthly

Replace/As needed

Quarterly or as required

6 Months or as required based on use.

SPECIFICATIONS

Electrical

Input Voltage:

120VAC

Standby PWR:

Typically < 1W

System Power: 1150W

Vacuum Motor: 120V, 11A

Usable Hose Length: 41 Feet

Frequency: 60Hz

Active Current: 0.6-0.8Amps (Dir Dependent)

Retractor PWR: 95-130W

Power Brush Receptacle: 120V, 2 Amps

Mechanical

Hose Management Cabinet:

Height: Front: - 58 ¼”, In wall(rear) 57”

Width: Front: -16 5/8”, In wall(rear) 14 3/16”

Depth: 6 ½” (At smallest height of Transition Cover)

Weight(45’ Hose): 53.285lb (less carton)

Vacuum Cabinet: 16 ¾”W x 12”H x 7 1/8”D

Weight(45’ Hose): 18.352lbs (less carton)

Dust bag capacity: 1 Gal US

PARTS LIST

B5-006-3 (Filter Bag, PAP Doc IT ALL, 5 Ply-3 Pack)

PN: MOD-10102

Canavac Systems Inc © 2013

22

Rev.3.0 www.canavac.com