PARTS LIST. BlueStar 17-inch

Below you will find brief information for Electric Grout Scrubber 17-inch. This manual provides all the information you need to operate and maintain your new scrubber. The 17-inch Electric Grout Scrubber is ideal for cleaning grout lines and other hard-to-reach areas. It comes equipped with a powerful motor and a vacuum system that removes excess solution and debris. The scrubber also features a brush pressure gauge that allows you to adjust the pressure of the brush against the floor for optimal cleaning results. Be sure to follow the instructions carefully to ensure safe and effective use.

PDF Download
Document
PARTS LIST. BlueStar 17-inch | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Powerful motor
  • Brush pressure gauge
  • Vacuum system
  • Solution tank
  • Double scrub option
  • Various attachments

Frequently asked questions

The brush pressure gauge indicates the pressure of the scrub brush on the floor. The brush pressure needle should be at the top of the green zone for the best scrubbing results.

The brush down pressure knob adjusts the pressure of the scrub brush against the floor. The brush down pressure knob is located on the underside of the scrub head lift lever. To increase the scrub brush pressure, turn the pressure knob to the left. To decrease the scrub brush pressure, turn the knob to the right.

Use manufacturer–supplied detergents for best results. Do not use more detergent than is recommended for the job. Powdered detergents are not recommended. Do not use flammable materials in the solution tank.

Loosen the drain plug by turning the drain plug knob to the left. Remove the drain plug while holding the hose up. Quickly lower the hose to the floor drain, as the solution rushes out of the drain hose. Flow rate can be reduced by squeezing the hose.

Pour 3.8 L (1 gal) of pre-mixed automotive-type windshield washer solution into the solution tank. Move machine over floor drain and plug the power cord into an outlet. Set the MODE switch in the WAND position. The pump will start and spray through the feed tube to the floor. Run in this manner until all of the solution is dispensed.
Preparing document for printing…
0%