Configuration. Atmel SAM9M10 EKES

Below you will find brief information for evaluation kit SAM9M10 EKES. The SAM9M10-EKES is a fully-featured evaluation platform for the Atmel SAM9M10-based microcontroller. The evaluation kit allows users to extensively evaluate, prototype and create application-specific designs. It includes many hardware peripherals such as two high speed USB hosts and one high speed device port, an Ethernet 10/100 interface, two high speed multimedia card interfaces, an LCD TFT display (480RGB272) with touch panel, a composite video output, a camera interface, and several communication peripherals such as Universal Synchronous/Asynchronous Receiver Transmitter (USART), Serial Synchronous Controller (SSC), and Two-Wire Interface (TWI). The external memory block is made of 3 memory types: DDR2-SDRAM, NAND Flash, and NOR Flash.

PDF Download
Document
Configuration. Atmel SAM9M10 EKES | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Two high speed USB hosts and one high speed device port
  • Ethernet 10/100 interface
  • Two high speed multimedia card interfaces
  • LCD TFT display (480*RGB*272) with touch panel
  • Composite video output
  • Camera interface
  • Various communication peripherals

Frequently asked questions

The board features the Atmel SAM9M10-CU, and this chip runs at a nominal frequency of 400 MHz for the core and 133 MHz for the system bus.

The SAM9M10-EKES board is equipped with 128 MB of DDR2-SDRAM memory, and the External Bus Interface (EBI) is connected to three kinds of memory devices: Parallel Flash, DDR2-SDRAM, and NAND Flash.

The board provides a standard 20-pin JTAG connection, which allows connection to standard USB-to-JTAG in-circuit emulator.

The board features an AD1981B AC97 SoundMAX® CODEC for digital sound input and output. This interface includes audio jacks for MIC input, Line audio input, Headphone line output, and a speaker output connector.
Preparing document for printing…
0%