6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
HDMI IN
SYNC
HDMI OUT
LINK EDID SERVICE
STD TV
POWER
DC 24V
1 2 3 4 5 6 7 8
1
HDMI IN: Connect with source equipment such as DVD/Blu-ray or
PS3 player.
2
SYNC: This LED will illuminate when the HDMI input port connected to an active source.
3
HDMI OUT: Connect to HDMI display for instant image display or cascade with another family type Transmitter.
4
HDMI LINK: This LED will illuminate when HDMI output is connected to TV or display monitor.
5
EDID STD/TV: The default factory setting is on STD, leave as it is when the display is properly. When in TV mode, the unit will detect the 1 st
CAT5e/6/7 output’s EDID when it obtain a 4Kx2K EDID and send out the signal accordingly to other output ports. If the 1 st
CAT5e/6/7 output is without a 4Kx2K's EDID the unit will detect all output's EDID and send out the signal that all outputs can accept.
This device obtain the last memory function therefore, the device
will use the last output port 1's EDID when output port 1 is not connected to a display after power cycling or switching in between the EDID setting.
STD EDID’s video at 1080p@60Hz and audio at LPCM 2CH.
6
SERVICE: This slot is reserved for factory service only.
7
POWER LED: Once the power supply is connected the LED will illuminate
8
DC 24V: Plug the 24V DC power supply into the unit and connect the adaptor to an AC outlet.
3