Overheating protection. Miele KM 411

Add to My manuals
20 Pages

advertisement

Overheating protection. Miele KM 411 | Manualzz

Using the barbecue

Overheating protection

An overheating protection switch automatically turns off the appliance if the water level drops too low.

^ Add water to the trough.

When the appliance has cooled down and the grill element turns itself back on you can continue grilling.

After grilling

^ Turn off the grill.

^ Clean the grill after each use while it is still warm (but, not hot)! See the

"Cleaning and care" section for details.

^ Check the appearance of the lava rocks. If the rocks are dark or saturated with oil, they should be replaced.

13

Cleaning and care

Under no circumstances use a steam cleaner to clean this appliance. Pressurized steam could cause permanent damage to the surface and to components for which the manufacturer cannot accept responsibility.

Never use strong cleaners e.g. oven sprays, stain or rust removers.

Scouring pads and abrasive cleaning agents should only be used on the heating element.

Do not use any sharp pointed objects which could damage the seal between the ceramic surface and the surrounding frame and between the frame and the countertop.

When using cleaning agents for stainless steel you must follow the manufacturer’s instructions on the packaging.

After cleaning use a soft, dry cloth to remove any moisture. This way you will prevent the build up of limescale deposits.

Control panel

Ceramic surfaces can be cleaned with a damp cloth.

Wipe dry using a soft cloth.

,

Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage.

Stainless steel

Clean stainless steel surfaces with warm water and liquid dish soap applied with a non-abrasive sponge and then wipe dry with a soft cloth. Soak baked or hardened spills first to loosen them.

Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner.

To help prevent resoiling, a conditioner for stainless steel can also be used.

Apply sparingly with even pressure.

Do not use stainless steel conditioner on the lava rock container.

Grate, Lava rock container, heating element

Allow the appliance to cool down.

Clean the rack and the lava rock container after each use with a solution of liquid dish soap and warm water. Allow to dry thoroughly.

Soak to loosen any burnt-on food which can then be removed with a brush.

Use a gentle scourer on any residue left on the grill element.

14

advertisement

Key Features

  • Powerful heating element for quick and even cooking
  • Adjustable temperature control for grilling a variety of foods
  • Large grilling surface for cooking for a crowd
  • Nonstick coating for easy cleanup
  • Water trough to reduce smoke and flare-ups
  • Overheating protection for safety
  • Safety cut-out feature for added peace of mind

Related manuals

Frequently Answers and Questions

How do I clean the grill?
The grill should be cleaned after each use. To clean the grill, remove the lava rocks and water trough. Wash the lava rocks and water trough in hot soapy water. Wipe the grill grate with a damp cloth.
How do I replace the lava rocks?
The lava rocks should be replaced every 6 months or so. To replace the lava rocks, remove the old lava rocks and replace them with new lava rocks. Make sure that the new lava rocks are the same size as the old lava rocks.
How do I adjust the temperature of the grill?
The temperature of the grill can be adjusted by turning the temperature control knob. The temperature control knob is located on the front of the grill. Turn the knob to the desired temperature setting.

advertisement