Front Panel Functions. Plinius SB-301 Power Amplifier

Add to My manuals
22 Pages

advertisement

Front Panel Functions. Plinius SB-301 Power Amplifier | Manualzz

Front Panel Functions

The front of the Plinius SB-301 MKII Power Amplifier incorporates all the facilities you will require on a daily basis.

1

2 3

1. POWER LED

An LED in the centre of the front panel indicates the power is on. When first switched on, the display will vary in brightness until the initialisation sequence is completed, after which the LED remains lit.

2. MUTE SWITCH

It is not recommended practice to interfere with the input cables while the amplifier is switched on and connected to the loudspeakers, so a Mute button is fitted to interrupt the input signal. This allows you to connect and disconnect the input cables without the necessity of turning the amplifier off, or to mute the signal momentarily when desired.

3. STANDBY SWITCH

The standby switch operates the mute and low bias functions simultaneously to enable the unit to be switched into a low bias power saving mode while keeping the amplifier circuitry active. The amplifier is then ready for use and requiring only a few minutes of warm-up before the very best of the amplifier’s sonic qualities may be experienced. In Standby mode the LED is ON.

When the amplifier powers up from start, it will automatically go into Standby and disconnect the speaker outputs. The standby switch or remote trigger can be used to take the unit out of Standby and begin listening. NOTE: The Standby mode will override mute. When taken out of standby the unit will return to the previous state.

POWER AMPLIFIER 7

advertisement

Related manuals