SYSTEM CONFIGURATION. Furuno FI-507 MULTI XL, FI504, FI507

SYSTEM CONFIGURATION

Standalone configuration

CAN bus Device or

NMEA 2000 Sensor

(ex. Smart Sensor)

FI-504

FI-507

12 VDC

: Standard Supply

: Optional Supply

: Local Supply

NOTICE: Turn on the terminal resistor in the instrument when connecting an NMEA 2000 sensor or CAN bus device. For the procedure, see the section on setting up, in the installation chapter.

v

SYSTEM CONFIGURATION

CAN bus network

FI-504 MULTI

FI-507 MULTI XL

FI-5001 or

FI-5001L

WIND

TRANSDUCER

TERMINAL BOX

(where necessary)

FI-501* and/or

FI-502

FI-505

COURSE PILOT

FI-506

RUDDER

30

FI-503

DIGITAL

CAN bus

Device or

NMEA 2000

SENSOR*

* NMEA 2000 SENSORS

- Boat speed

- Depth

- Heading

- Navigation

- Environment

- Autopilot

- Engine

*FI-501 Wi nd Angle

FI-502 Close Hauled Wind Angle

CAN bus

Device or

NMEA 2000

SENSOR*

CAN bus

Device or

NMEA 2000

SENSOR*

JUNCTION BOX

FI-5002

CAN bus

Device or

NMEA 2000

SENSOR*

CAN bus

Device or

NMEA 2000

SENSOR*

12 VDC

(not necessary if powered by CAN bus network)

: Standard Supply

: Optional Supply

: Local Supply

NOTICE: Turn on the terminal resistor in the terminator of the CAN bus network.

vi