Installation Overview
The installation procedure includes the following major steps:
1. Prepare to install the adapter.
2. Shut down the operating system and switch off the power to the computer.
3. Install the adapter.
4. Attach the adapter to the network.
5. Configure the adapter.
6. Verify operation.
Product Description
The HP-PB 100Base-T Network Adapter provides the hardware needed to interface an HP-PB backplane to a 100Base-T Network.
The HP-PB 100Base-T Network Adapter has the following features:
• one built-in RJ-45 connector, for attachment to the hub
• 10 or 100-Mbit per second operation
• single-high form factor
Product Contents
• HP-PB 10/100Base-TX Network Adapter — A3495-60001
• Installation and Service Manual — B5427-90001
Tools and Accessories
Before installation, gather these tools and accessories:
• screwdrivers necessary for opening your computer and installing adapters
• grounding wrist strap
• cable for attachement to network (UTP category 5, not supplied)
10