- No category
advertisement
8
INSTALLATION INSTRUCTIONS
INTERIOR-MOUNTED VENT MOTOR
Island location
Venting Methods - Interior Mounted Vent Motor Only
Determine which venting method is best for your application.
Vent system can terminate through either the wall or floor.
Island Location
Vent system installed under a concrete slab using PVC sewer pipe.
Front (Standard) Mounted Blower Motor
Front (standard) mounted blower motor
Rear mounted blower motor
B
A
D
A. Down vent
NOTE: For island locations, the blower motor can be mounted for right, left, or rear venting if needed for your application. Most island applications would still require the venting to be directed down through the floor.
Built-in cabinet locations
A
A
B
A
M
C
E
F
H
G
L
K
J
Rear Mounted Blower Motor
B
I
A
D
M
C
E
F
G
L
H
K
J
I
A. Wall cap
B. 6" (15.2 cm) round metal vent
C. 16" (40.6 cm) maximum
D. 6" (15.2 cm) round PVC sewer pipe
E. 6" (15.2 cm) round metal vent
F. 6" (15.2 cm) round PVC coupling
G. Concrete slab
H. 6" (15.2 cm) round PVC sewer pipe
I. 6" (15.2 cm) round 90° PVC sewer pipe elbow
J. Tightly pack gravel or sand completely around pipe.
K. 6" (15.2 cm) round 90° PVC sewer pipe elbow
L. 6" (15.2 cm) round PVC coupling
M. 12" (30.5 cm) minimum
D
C
A. Down vent
B. Rear vent
C. Left vent
D. Right vent
Calculating Vent System Length
It is recommended that you use round vent instead of rectangular vent, especially if elbows are required. If rectangular vent is required, it should be transitioned to 6" (15.2 cm) round vent as soon as possible.
Maximum Length of Vent System
Vent Length
6" (15.2 cm) round
3
¹⁄₄" x 10" (8.3 cm x 25.4 cm)
35 ft (8.9 m)
35 ft (8.9 m)
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 VENT SYSTEM SAFETY
- 5 INSTALLATION REQUIREMENTS
- 5 Tools and Parts
- 5 Location Requirements
- 7 Electrical Requirements
- 7 Venting Requirements
- 8 INTERIOR-MOUNTED VENT MOTOR
- 8 Venting Methods - Interior Mounted Vent Motor Only
- 9 Install Vent System
- 13 Rear Mounting - Blower Motor
- 15 Complete Installation
- 15 Make Electrical Connections
- 16 Check Operation
- 17 VENT SYSTEM USE
- 17 Operating Downdraft Vent
- 17 VENT SYSTEM CARE
- 17 Surface of Downdraft Vent
- 17 Filters
- 18 WIRING DIAGRAM
- 19 ASSISTANCE OR SERVICE
- 20 WARRANTY
- 22 SÉCURITÉ DU SYSTÈME DE VENTILATION
- 24 EXIGENCES D'INSTALLATION
- 24 Outillage et pièces
- 24 Exigences d'emplacement
- 26 Spécifications électriques
- 26 Exigences concernant l'évacuation
- 27 VENTILATEUR MONTÉ À L'INTÉRIEUR
- 27 ventilateur monté à l'intérieur
- 28 Installation du système d’extraction
- 32 Montage du ventilateur à l'arrière
- 34 Achever l'installation
- 34 Raccordements électriques
- 35 Contrôle du fonctionnement
- 36 UTILISATION DU SYSTÈME D'EXTRACTION
- 36 Utilisation du système d'extraction
- 36 ENTRETIEN DU SYSTÈME D'EXTRACTION
- 36 Surface du système d'extraction
- 36 Filtres
- 37 SCHÉMA DE CÂBLAGE
- 38 ASSISTANCE OU SERVICE
- 39 GARANTIE