Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

Add to my manuals
138 Pages

advertisement

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide | Manualzz

A P P E N D I X

B

Declarations of Conformity and Regulatory

Information

This appendix provides declarations of conformity and regulatory information for the Cisco Aironet

1130AG Series Access Points.

This appendix contains the following sections:

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Department of Communications—Canada

European Community, Switzerland, Norway, Iceland, and Liechtenstein

Declaration of Conformity for RF Exposure

Guidelines for Operating Cisco Aironet Access Points in Japan

OL-6226-02

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

B-1

Appendix B Declarations of Conformity and Regulatory Information

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Manufacturers Federal Communication Commission

Declaration of Conformity Statement

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

Model:

AIR-AP1131AG-A-K9

FCC Certification number:

LDK102054

Manufacturer:

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1.

2.

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from which the receiver is connected.

Consult the dealer or an experienced radio/TV technician.

Caution

The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could void the user’s authority to operate this device.

B-2

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

OL-6226-02

Appendix B Declarations of Conformity and Regulatory Information

Department of Communications—Canada

Caution

Within the 5.15 to 5.25 GHz band (5 GHz radio channels 34 to 48) the U-NII devices are restricted to indoor operations to reduce any potential for harmful interference to co-channel Mobile Satellite System

(MSS) operations.

Department of Communications—Canada

Model:

AIR-AP1131AG-A-K9

Certification number:

2461B-102054

Canadian Compliance Statement

This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du

Canada.

This device complies with Class B Limits of Industry Canada. Operation is subject to the following two conditions:

1.

2.

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation.

Cisco Aironet 2.4-GHz Access Points are certified to the requirements of RSS-210 for 2.4-GHz spread spectrum devices, and Cisco Aironet 54-Mbps, 5-GHz Access Points are certified to the requirements of

RSS-210 for 5-GHz spread spectrum devices.The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. For further information, contact your local Industry Canada office.

European Community, Switzerland, Norway, Iceland, and

Liechtenstein

Model:

AIR-AP1131AG-E-K9

OL-6226-02

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

B-3

Appendix B Declarations of Conformity and Regulatory Information

European Community, Switzerland, Norway, Iceland, and Liechtenstein

Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC

English:

Deutsch:

Dansk:

Español:

Έλληνας:

Français:

Íslenska:

Italiano:

Nederlands:

Norsk:

Português:

Suomalainen:

Svenska:

This equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

Dieses Gerät entspricht den grundlegenden Anforderungen und den weiteren entsprecheneden Vorgaben der Richtlinie 1999/5/EU.

Dette udstyr er i overensstemmelse med de væsentlige krav og andre relevante bestemmelser i Directiv 1999/5/EF.

Este equipo cumple con los requisitos esenciales asi como con otras disposiciones de la Directive 1999/5/EC.

Αυτός ο εξοπλισµός συµµορφώνεται µε τις ουσιώδεις απαιτήσεις και τις λοιπές

διατάξεις της Οδηγίας 1999/5/EΚ.

Cet appareil est conforme aux exigencies essentialles et aux autres dispositions pertinantes de la Directive 1999/5/EC.

Þessi búnaður samrýmist lögboðnum kröfum og öðrum ákvæðum tilskipunar

1999/5/ESB.

Questo apparato é conforme ai requisiti essenziali ed agli altri principi sanciti dalla

Direttiva 1999/5/EC.

Deze apparatuur voldoet aan de belangrijkste eisen en andere voorzieningen van richtlijn 1999/5/EC.

Dette utstyret er i samsvar med de grunnleggende krav og andre relevante bestemmelser i EU-directiv 1999/5/EC.

Este equipamento satisfaz os requisitos essenciais e outras provisões da Directiva

1999/5/EC.

Tämä laite täyttää direktiivin 1999/5/EY oleelliset vaatimukset ja on siinä asetettujen muidenkin ehtojen mukainen.

Denna utrustning är i överensstämmelse med de väsentliga kraven och andra relevanta bestämmelser i Direktiv 1999/5/EC.

For 2.4 GHz radios, the following standards were applied:

Radio:

EMC:

Safety:

EN 300.328-1, EN 300.328-2

EN 301.489-1, EN 301.489-17

EN 60950

Note

This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain frequencies and/or may require a license for operation. For more details, contact Cisco Corporate

Compliance.

B-4

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

OL-6226-02

Appendix B Declarations of Conformity and Regulatory Information

Declaration of Conformity for RF Exposure

For 54 Mbps, 5 GHz access points, the following standards were applied:

Radio:

EMC:

EN 301.893

EN 301.489-1, EN 301.489-17

Safety: EN 60950

The following CE mark is affixed to the access point with a 2.4 GHz radio and a 54 Mbps, 5 GHz radio:

Declaration of Conformity for RF Exposure

The radio has been found to be compliant to the requirements set forth in CFR 47 Sections 2.1091, and

15.247 (b) (4) addressing RF Exposure from radio frequency devices as defined in Evaluating

Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields. The equipment shoud be installed more than 20 cm (7.9 in.) from your body or nearby persons.

The access point must be installed to maintain a minimum 20 cm (7.9 in.) co-located separation distance from other FCC approved indoor/outdoor antennas used with the access point. Any antennas or transmitters not approved by the FCC cannot be co-located with the access point. The access point’s co-located 2.4 GHz and 5 GHz integrated antennas support a minimum separation distance of

8 cm (3.2 in.) and are compliant with the applicable FCC RF exposure limit when transmitting simultaneously.

Note

Dual antennas used for diversity operation are not considered co-located.

OL-6226-02

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

B-5

Appendix B Declarations of Conformity and Regulatory Information

Guidelines for Operating Cisco Aironet Access Points in Japan

Guidelines for Operating Cisco Aironet Access Points in Japan

This section provides guidelines for avoiding interference when operating Cisco Aironet access points in Japan. These guidelines are provided in both Japanese and English.

Model:

AIR-AP1131AG-J-K9

Japanese Translation

03-5549-6500

English Translation

This equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices such as microwave ovens and mobile object identification (RF-ID) systems (licensed premises radio stations and unlicensed specified low-power radio stations) used in factory production lines.

1.

Before using this equipment, make sure that no premises radio stations or specified low-power radio stations of RF-ID are used in the vicinity.

2.

3.

If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the frequency or stop using the device; contact the number below and ask for recommendations on avoiding radio interference, such as setting partitions.

If this equipment causes RF interference to a specified low-power radio station of RF-ID, contact the number below.

Contact Number: 03-5549-6500

B-6

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

OL-6226-02

Appendix B Declarations of Conformity and Regulatory Information

Declaration of Conformity Statements

Declaration of Conformity Statements

All the Declaration of Conformity statements related to this product can be found at the following URL: http://www.ciscofax.com

Declaration of Conformity Statements for European Union

Countries

The Declaration of Conformity statement for the European Union countries is listed below:

OL-6226-02

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

B-7

Declaration of Conformity Statements for European Union Countries

Appendix B Declarations of Conformity and Regulatory Information

DECLARATION OF CONFORMITY with regard to the R&TTE Directive 1999/5/EC

according to EN 45014

Cisco Systems Inc.

170 West Tasman Drive

San Jose, CA 95134 - USA

Declare under our sole responsibility that the product,

Product:

AIR-AP1131AG-E-K9

Cisco Aironet 1130AG Series IEEE802.11 a/b/g Access Point

Fulfils the essential requirements of the Directive 1999/5/EC

The following standards were applied:

EMC EN 301.489-1 v1.4.1: 2002-08; EN 301.489-17 v1.2.1: 2002-09

Health & Safety EN60950: 2000; EN 50385: 2002

Radio EN 301.893 v 1.2.3: 2003-08

EN 300 328 v 1.4.1: 2003-04

The conformity assessment procedure referred to in Article 10.4 and Annex III of

Directive 1999/5/EC has been followed.

The product carries the CE Mark:

Date & Place of Issue: 1 April 2005, San Jose

Signature:

Tony Youssef

Director Corporate Compliance

Cisco Systems, 125 West Tasman Drive

San Jose, CA 95134 - USA

Additional information:

EMC Test Report:

Cisco Systems EDCS-382866

Safety Test Report:

Radio Test Report:

CCS: 04U2603-8; UL: E-145532

CCS: 04U2603-4 (2.4 GHz) & 04U2603-11 (5 GHz)

DofC 441919

B-8

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

OL-6226-02

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents